USER’S MANUAL
Bluetooth Speaker S156S
Charging The Bluetooth Speaker
1. Connect the Bluetooth Speaker’s Micro USB socket (2) with the Computer’s USB port
through USB cable.
2. The Charging LED (3) will turn ON in red light; the rechargeable battery is in charging.
3. The Charging LED (3) red light will turn OFF when the rechargeable battery is fully
charged.
Bluetooth Speaker Pairing / Reconnecting
1. Press and hold the button (1) , a message sound; “Di” will announce from speaker and the
Mode LED (3) will blinking in blue; the device is turned ON and goes into searching / paring
/ reconnect mode for pair.
2. Now, turn ON the Bluetooth function on your mobile phone.
3. Search for “Armin Retro Speaker” and select it to pair. (for first time pairing or pairing
a new mobile device)
4. The Bluetooth Speaker will be reconnecting automatically if your mobile phone has been
paired. (Depend on the of mobile phone’s type and configuration, manual reconnection
may require on some devices)
5. If pairing is successful, a message sound; “Di-” will announce from speaker and the Mode
LED (2) light will switch to slow blink in blue (once per 2 seconds ).
6. Press and hold the button (1) to turn OFF the Bluetooth Speaker.
Bluetooth Speaker Control Function
In playing music, press button (1) to pause music, press it once again to play.
Hand Free Function
1. When there is an incoming call; The ringing sound will up and the playing music will pause
automatically. Press button (1) to pick up the call if you want. Now you have hand free
function with the Bluetooth speaker.
2. Press button (1) again to hand up the call when finished. The paused music will start to
play automatically.
Tip: speak to the MIC hole direct with distance in 30 cm to get the best speakerphone
performance when necessary.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures: ‐‐Reorient or relocate the receiving antenna.
‐‐Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
‐‐Consult the dealer or an experienced radio/TV technician for help.
Loading...