Reznor R8GD User Manual

INSTALLATION INSTRUCTIONS FOR

INSTALLATION

547846 / 547847

HAIL GUARD USED WITH R4GM 072

INSTRUCTIONS

P6SD, Q6SD, R6GD 024-060 UNITS

FORM# 601A-0808 (601A-0298)

The Hail Guard is designed to prevent damage to the condensor coil of the unit. The following list of parts are required:

Step 1:

Check for correct number of parts. See
list below.

1 - Rear Hail Guard (A)
2 - Side Hail Guard (B & C)
1 - Rear Top Panel (D)
2 - Side Top Panel (E & F)
6 - Vertical Side Panel (G)
1 - Hardware Package

E

G

B

D

F

A

G

G

C

44 - #10- 16 x ½ Screw
1 - Installation Instruction

Fig ure 4

Step 2:

Take (G) vertical side panels and
assembly to their respective top panel
(D), (E) and (F)

Step 3:

Secure (A), (B) and (C) hail guards in
between clips on the vertical side panels
and close clips to hold guard in position.

Step 4:

Slip top flange of the assembled kit under
the top pan of the unit and fasten to unit.
Use the existing screws on the unit and
self-drilling screws to attach to the corner
posts.

CORNER POST

FLANGE

Fig ure 5

SIDE HAIL GUARD

SUPERSEDES 10-26-04
SEPTEMBER 2, 2008

REAR HAIL GUARD

SIDE HAIL GUARD

Fig ure 6

NEIHG06