Reznor FE 25-400 User Manual

Form I-F-CH1 (Version .1)

Obsoletes Installation Form RZ/NA I-F-SW

Installation Instructions

Applies to: Manual Summer/Winter Fan Switch

Option CH1, for Models F & FE 25-400

Description and Application

General

The optional summer/winter switch is designed to provide manual control of fan operation.

The option package includes:

Option CH1

Manual Summer/Winter

Fan Switch Qty

Option Package P/N 98485

Summer/Winter Switch with pull cord 1 98148

Instruction Sheet 1 98294

F and FE

25-400

P/N

Cautions and Warnings

There are warning labels on the unit, on the front page, and throughout this manual. For your safety, comply with all warnings during installation, operation, and service of

this system. Denitions of the hazard intensity levels of the cautions, warnings, and

dangers are shown below.

HAZARD INTENSITY LEVELS

1. DANGER: Failure to comply will result in severe personal injury or death and/or property damage.

2. WARNING: Failure to comply could result in severe personal injury or death and/or property damage.

Installation Instructions

3. CAUTION: Failure to comply could result in minor personal injury and/or property damage.

Installation should be done by a qualied agency in accordance with these instructions

and in compliance with all codes and requirements of authorities having jurisdiction.

Tools Required: One 5/16" Nut Driver.

1. If the heater is installed, turn off the gas and turn off the electrical power.

2. Remove the outer side panel on the left side of the heater (left when facing the back of the heater), exposing the inner side panel and wiring.

3. On the rear edge of the inner side panel, locate a 1/2"diameter hole (See Figure 1 shown on page 2). Insert the chain and the front of the switch through the hole. Arrange the knurled nut as shown in Figure 1 and tighten rmly by hand.

4. Wire the summer/winter switch as shown on the specic wiring diagram included with your heater or refer to the general diagram shown on page 2.

5. Replace the outer side panel as shown in Figure 2 on page 2.

6. Install the pull cord on the summer/winter switch.

7. If the heater is installed, turn on the electric power and the gas and re-light, following the instructions on the heater. Check the operation of the summer/winter switch. CHECK FOR PROPER OPERATION OF ALL SAFETY FEATURES.

If the heater is not installed, be sure to support the bottom with plywood or other appropriate material. Follow the installation instructions provided with the heater and check for proper operation of the summer/winter switch.

Form I-F-CH1 (Version .2), PN 98294R2, Page1

Place chain through hole first.

1/2”diameter hole

Left Inner Side Panel

Switch

Inner Nut

Figure 1

Outer Knurled Nut

Manual Summer/ Winter Fan Switch

Figure 2

Wiring Diagram - Option CH1, Manual Summer/

Winter Switch on Fan-Type Unit Heater

Form I-F-CH1 (Version .2), PN 98294R2, Page2

www.ReznorHVAC.com; (800) 695-1901

Trademark Note: Reznor

0514 (Serial No. Date Code BNE) Form I-F-CH1 (Version .2), PN 98294R2

is registered in at least the United States.