Revent 726 User Manual

726 Single Rack

gaS Oven

Available in gas, oil or electrically heated models.
Accepts one single rack 18” x 26” or 20” x 30” pans

Revent’s line of innovative baking technology is made to
take any bread to the highest level. In bread we trust.

Revent TCC System (Total Convection Control)
Revent HVS System (High Volume Steam

726 USG 120425

Standard features

> Revent TCC System
> Revent HVS System
> Revent LID System
> Revent Cross Line Heat Exchanger
> Revent Wedge Installation System
> Stainless Steel Design
> GIAC (Graphic InterActive Control) Panel
> Automatic Steam and Damper Control
> Double glass door

Utility Requirements

Gas
> Natural Gas: Indirect fired ¾” drop to ½”

NPT connection

> Liquid Propane: Indirect fired ¾” drop to

½” NPT connection
Water and Drain
> Water Supply : ½” NPT ø 60-65 PSI cold
> Drain: 1” NPT, optional connection to rear
Ventilation
> Over Pressure Duct: through door to canopy
> Oven Damper Exhaust: through door to

canopy
> Canopy Port: 9.9” ø
> Oven Stack Exhaust: 8” ø, Type ”B” gas

and oil versions only

Technical information

> Maximum Heat Capacity:see table below
> Temperature range: 95-572°F
> Total shipping weight: 2425 lbs*
> Minimum intake opening: without skid:

39” x 56” with skid: 41.5” x 62” (standard
2 section delivery)

> Minimum intake opening: 55.2”x57.1”

(optional one-piece shipment without skid)

> Mimimum section tilt up height and

recommended service height: 106”
> Swing diameter: 37.4”
> Max load of racklift and platform 441 lbs
> Steam Generation 1.19gals/20sec at 482°F
> Installation requirements: The oven must

be installed on level non combustible

floor. The oven may be installed flush

against a wall - only the front and top

need to be left for access. The space on top

of the oven must be well ventilated and

the temperature may not exceed 120°F to

avoid damage to electrical components.

726 Oil/gas heated

Voltage

3PH208–220V+N

3PH440–480V
+ 1 PH 115V

NOTE:
Other voltages available, check with factory.
Limited warranty, one year parts+labor

*Final shipping
Weights will depend on the final order specifications.

Continuous product development is a Revent
policy. Therefore, we reserve the right to change
specifications and/or design without prior notice.
Pictures or drawings may include product options.

Heating

170000 btuh

170000 btuh

Fuse

20A

15A

Revent sales representive:

Revent Incorporated
100 Ethel Road West, Piscataway, New Jersey 08854
Phone [phone], Fax [phone]
Toll Free 800-822-9642
E-mail [e-mail], www.revent.com