REVELL Skateboard Racer Kit User Manual [en, fr, nl, it, gr, da, no, fi, sv, es, pt, de, en, hr, et, fi, hu, lv, lt, nl, pl, ro, ru, sr, sk, sl, cs, tr, gr, bg, uk, ch, he, ar, ja, ch, ch, ko, hi, id, kk, ms, fa, pt, es, th, vi, sq, mk]
WWW.REVELL.COM
SKATEBOARD RACER SETSKATEBOARD RACER SETSKATEBOARD RACER SET
Read the entire instruction
sheet before beginning
assembly. Adult supervision
is required!
Assembly Instructions
1
Contents
1. (1) Precut Wood Block
2. (4) Axles
3. (4) Wheels
1. Sand the body
using coarse (120
grit) sandpaper
rst, followed by
medium (220 grit)
paper. Optional:
to smooth out the
racer, use ner
paper.
2. Test t the
wheels and axles
for proper t.
Adjust as needed.
Set them aside for
later use.
INSTRUCTIONS
4. (1) Stick-On Chassis Weight
5. (2) Decal Sheets
6. (1 each) Sandpaper 120 & 220 Grit
Installing the Wheels and Axles
3
WARNING:
CHOKING HAZARD — Small parts.
Not for children under 3 years of age.
3. Use a foam
brush1 to apply an
even layer of clear
1
coat.
Extra layers
can be applied if
needed.
1. Place a wheel on
each of the axles,
and press them
into the axle slots
on the bottom of
the racer.
Detail the Body
2
needed. Do not scu the nal coat.
1. Clean all dust
from the racer.
Apply a thin coat of
1
paint
as evenly as
possible. When dry,
use ne sandpaper
to lightly scu
the paint. Apply
additional coats as
2. Test t the
decals with the
backing still on.
Once you are sure
of their placement,
peel o the
backing and apply.
2. Space each
wheel to have
a small gap.
Place the wheel
adjustment tool
between the racer
and the wheel.
Move the axle and
wheel until the
tool ts snugly
between the inside of the wheel and the outside of the racer.
3. Place the kit
on a smooth, at
surface. Place a
wheel adjustment
2
tool
with the
camber check
section against the
face of the wheel.
Adjust each axle to
make the wheels
parallel to the edge of the adjustment tool.
2
P
AGE 2
PAGE 2
WWW.REVELL.COM
4. Apply graphite
powder
the inside of the
axle head and
outside of the
wheel. Slowly turn
the wheel and
shake the kit to
work the powder
into the wheel.
5. Apply graphite
powder3 to the
inside of the wheel
where it makes
contact with the
body.
3
between
Weight the Car
4
1. Weigh the kit
with all the parts
installed. Use a
pair of pliers to
break off as many
sections of weight
as needed to
meet the 5 oz (141
gram) limit.
2. Attach the
weight to the
bottom of the kit
using the double
sided foam tape.
1 We recommend the Revell Paint & Brush Set (RMXY9630)
2 We recommend the Revell “O cial Pinewood Derby® Wheel Adjustment Tool™” (RMXY9616)
3 We recommend Revell Graphite Powder (RMXY9614)
REVELL® INC. 1850 HOWARD ST., UNIT A, ELK GROVE VILLAGE, IL 60007 U.S.A.
MADE IN CHINA • ENTIRE CONTENTS © COPYRIGHT 2009
RMXY9638
Loading...