REVELL Revellutions Chiller User Manual

1

™

55-3979

Radio Controlled Buggy
Carrito con Tadiocontrol
Buggy Télécommandé

RMXC3979 Chiller Mnl.indd 1 4/18/2013 10:32:22 AM

2

™

CHILLER

™

•

Radio-controlled kit with 2.4GHz

technology.

•

Pistol-type controller.

REQUIRED BATTERIES

Batteries: (4) 1.5 V “AA”
(not included)

SAFETY INSTRUCTIONS

•

This vehicle is suitable for children who

are at least 10 years of age. Parental
supervision is required.

•

This vehicle is suitable for use indoors

and in a safe outdoor area.

•

Keep your hands, face and loose clothing

away from the vehicle.

•

Switch off the controller and vehicle when

not in use.

•

Remove batteries from the controller and

vehicle when not in use.

•

Do not drive near people, animals, bodies

of water or power lines.

•

Never disassemble or alter the battery.

Do not damage or puncture the batteries.

•

Only recommended batteries or those of

an equivalent type may be used.

•

Keep out of reach of children.

•

The electronics are protected from dust

and splashing, but complete immersion
or driving in water for an extended period
must be avoided! After use, remove the
battery and dry completely!

•

Do not expose the controller and

charging unit to moisture!

•

Never throw batteries into a fi re or store in

hot places.

•

Only use the supplied charger to charge

the battery.

•

Do not leave the battery unsupervised

during charging.

•

When disposing of batteries, they must

be fully depleted. Cover exposed
terminals with adhesive tape.

•

Rechargeable batteries may only be
charged under the supervision of an adult.

•

Combinations of different types or new

and used batteries may not be used.

•

Never store the battery in the charger base.

MAINTENANCE AND CARE

•

Use a clean, damp cloth to wipe off the

vehicle.

•

Protect the vehicle and batteries from

direct sunlight and/or heat.

•

Never allow the controller or charger to

come into contact with water. Damage
may result.

FCC REQUIREMENT

This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions.

(1) This device may not cause harmful

interference.

(2) This device must accept any

interference received, including
interference that may cause undesired
operation.

NOTE: THE MANUFACTURER IS NOT
RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY
TO OPERATE THE EQUIPMENT.

CAUTION – ELECTRIC TOY

Not recommended for children under 8
years of age. As with all electrical products,
precautions should be observed during
handling and use to prevent electric shock.

Input: 120V AC, 60Hz;
Output: 6V DC 0.5A

This product contains a NiMH
battery. Must be recycled or
disposed of properly.

WARNING: This product contains a
chemical known to the State of California to
cause cancer.

ON/OFF

switch

Gear
lever

Battery

Charger

base

Charger

Steering

Throttle

Power LED

ON/OFF

switch

Quick-change

wheels

Battery

locking disk

CHILLER

™

CONTROLLER ACCESSORIES

RMXC3979 Chiller Mnl.indd 2 4/18/2013 10:32:23 AM

3

English

INSERTING BATTERIES

1. Unscrew the battery cover.

2. Insert 4 x 1.5V AA batteries. Re­install the cover.

CHARGING THE VEHICLE

Attention: After each use, the battery
and the motor must cool down for 10
to 15 minutes.

1. Open the battery lock and remove
the battery.

2. Plug the charger into a standard AC
outlet and the charger base.

3. Plug the battery into the charger
base. The charger LED glows red to
show that charging is in progress.
When the LED turns off, the battery is
fully charged.

4.Unplug the charger and remove the
battery.

5. Re-insert the battery in the vehicle.

START

1. Press the ON/OFF button on the
controller; the LED illuminates.

2. Move the ON/OFF switch on the
vehicle to the “ON” position.

VEHICLE CONTROL

AND DRIVING TIPS

•

To slowly drive forward, pull the

trigger slightly. To drive faster, pull the
trigger further.

•

To brake, push the trigger. To drive in

reverse, push again.

•

To turn, rotate the wheel to the left or
right.

•

Always move the controls slowly and

with a gentle touch.

•

During a crash, release the trigger.

GEAR SHIFTING

Attention! Do not switch while the
motor is running!

1.

Use low gear for indoors or large
inclines. Slide the lever to the left until it
locks.

2. Use high gear for open areas. Slide
the lever to the right until it locks.

RMXC3979 Chiller Mnl.indd 3 4/18/2013 10:32:36 AM

4

English

STEERING ADJUSTMENT

If your kit “pulls” to one side when the
steering wheel is pointed straight,
move the steering trim lever the
opposite direction. Adjust as needed.

WHEEL CHANGE

Pr

ess the r

etainer to pull the wheel off.
When replacing the wheel, make sure
the hex engages properly in the rim.

BATTERY SA

VER

After 5 minutes of no use, the contr

oller
makes a tone and the LED blinks. After
an additional 5 minutes, it switches of

f.
The vehicle switches off approximately 3
minutes after the controller. To resume
driving, switch the controller and vehicle
off and on again.

CONNECTING THE VEHICLE

AND CONTROLLER

The connection of your vehicle and
controller is established at the factory.
If necessary to re-establish connection,
proceed as follows:

1. Turn off the car and controller.

2. Pull the controller trigger and hold it.

3. T

urn the wheel all the way to the right

and hold it.

4. Turn on the controller and the LED
will begin to blink.

5. Hold the controller near the vehicle
and turn it on.

6. Once the controllers LED stops
blinking, the connection has been
made.

SERVICE

If your Revellutions Kit requir

es repairs or
replacement, DO NOT RETURN TO
RETAILER. Contact:

Hobby Services
3002 N. Apollo Drive, Suite 1
Champaign, Il, 61822, U.S.A.
9am-5pm Central Mon.-Fri.
[phone]

[e-mail]

TROUBLESHOOTING

Problem:

The vehicle slows down and stops for no apparent reason.

Cause:

The vehicle battery is too weak.

Remedy: Charge the battery.

Problem: The vehicle cannot be controlled with the controller.
Cause: The controller is switched off. The connection between the

controller and vehicle has been severed.
Remedy: Move the controller switch to the “ON” position.
Re-establish connection between the vehicle and controller.

Problem: Controller does not work.
Cause: The controller is switched off. The batteries were not inserted

correctly. The batteries do not have enough power.
Remedy: Repeat the switch-on process as described. Check that
the batteries are inserted correctly.

Problem: The car does not move.
Cause: The battery is too weak or depleted.
Remedy: Charge the battery (see “Charging the Vehicle”).

RMXC3979 Chiller Mnl.indd 4RMXC3979 Chiller Mnl.indd 4 4/18/2013 10:32:37 AM4/18/2013 10:32:37 AM

Industry Canada Notice:

This device complies with Industry Canada
licence-exempt RSS standard(s).

1.Operation is subject to the following two
conditions:

(1) this device may not cause interference,

and

(2) this device must accept any interference,

including interference that may cause

undesired operation of the device.

2.Changes or modifications not expressly

approved by the party responsible for

compliance could void the user’s

authority to operate the equipment.