Response SC379 User Manual
SC379
Model:
User Manual
Wireless MP3 USB
Door Chime Kit
Programming Proceedure 7
Download 7
a) Auto-Run 7
b) Editing 7
c) Build up the Play List 8
d) Play or Delete in the Play List 8
Kit Components 3
Safety Precautions 3
Contents
3Before you start
11Operation
13Troubleshooting
14Specification
4Installation
7Setting Up
Battery Installation 4
Bell Push 4
Portable Door Chime Unit 4
Installation Instructions 5
Bell Push 5
Chime Position 6
Chime Sounds 6
e) Synchronize 8
f) Memory 9
g) Disconnect 9
h) Tune/chime sound selection 9
Digital Code Set Up 9
1 First Time Operation 9
2 Interference from a similar unit
operating nearby 10
3 Front and back Door Bell Push operation 10
Door Chime Operation 11
Mode Selection 11
Adjust the Sound Volume 11
Low Battery Indicator 12
Technical Specification 14
Disposal 15
2
Before you start
■ Unpacking
Unpack your chime kit and identify the following parts:
• Chime Unit
• Bell Push
• 4 x Push Inserts (1 x each white, black, silver, brass colour)
• USB Cable
• Fixings
• User Manual
■ Safety Precautions
Before proceeding with the installation please note the following safety warnings:
• Always follow the manufacturer’s advice when using power tools and wear suitable protective
equipment (e.g. safety goggles) when drilling holes, etc.
• Before drilling holes in walls, check for hidden electricity cables and water pipes, the use of a
cable/pipe locater may be advisable if in doubt.
3
Installation
■ Battery Installation
Bell Push
The Bell Push is operated by 1 x 3volt CR2032
Lithium battery (included)
The Lithium battery (CR2032) has been installed.
To activate the battery remove the battery cover by inserting a small
flat-bladed screwdriver into the recess and push the battery cover
forward. Remove the isolation strip from the battery compartment,
then snap the cover back on. The Bell Push is now ready to use.
Bell Push battery replacement
Follow the instructions above to remove the battery cover and replace
the battery with 1 x 3volt CR2032 Lithium battery. Ensure the battery
polarity matches the internal markings (“+” face upward). Press the
battery down so that it is sitting firmly in its compartment. Snap the
back cover of Bell Push back on.
4
Portable Door Chime Unit
Remove the battery cover by pushing upwards on the arrow and insert
2 x 1.5volt alkaline batteries (“C”, UM2 & R14 – not included), ensure
the battery polarity matches the internal markings. The door chime is
ready to learn the operation code (please see Digital Code set up).
■ Installation Instructions
Bell Push
Using the two indentations of the back of the Bell Push as a template,
mark the fixing position of the bell push on the door frame, wall or
desired location by drilling through the indentations sufficiently to
leave marks indicating where to drill.
Insert wall plugs and secure the Bell Push battery compartment cover
with screws (self-tapping 3 x 16mm screw). Place the Bell Push over
the battery compartment cover and snap into place.
Important: Mounting the Push Button unit on the UPVC doorframes or a metal surface will reduce
the transmission range.
Note: The Bell Push can be fixed in position using sticky pads if preferred.
5
“C”, LR14
“C”, LR14
VolumeMode
Loading...