Response QM-8046, QM-8047 User Manual

Digital Wireless Reversing Camera

with 7" LCD Display

QM-8046

User Manual

IMPORTANT SAFETY INSTRUCTIONS

If you are not confident working with 12V/24V DC vehicle wiring, removing and reinstalling interior panels,
carpeting, dashboards or other components of your vehicle, contact the vehicles manufacturer, or consider
having the camera system professionally installed.

Do not attempt to open, modify or repair the product

Please read through the entire user manual before installation.

INSTALLATION

These instructions are only meant as a general guide due to the difference in vehicle makes and models. For

specific information, please contact your vehicles manufacturer.

Camera Installation

The camera can be tilted vertically to adjust the viewing angle. Make sure that its field of view is not
obstructed. There are several ways to mount the camera on the back of your car, but the most convenient
is to mount it near the license plate (as shown).

Please note: On some vehicles it may not be possible to mount the camera near the license plate. You may

have to find another spot at the back of your vehicle to mount it.

1. Remove the rear license plate, and then loosen the bolts/screws of the license plate.

2. Position the mounting plate of the camera behind the license plate bracket. Secure both license

plate bracket and mounting plate with the license plate bracket bolts/screws.

3. Reinsert the license plate on the license plate bracket.

4. Choose a routing path for the cameras power cable through the vehicles body to the reverse light

circuit.

5. Some vehicles may have a hole available to pass the wire through the trunk, otherwise you may

need to drill a hole close to where the power cable is attached to the camera. Once you have
chosen where the cable will enter the vehicles body, remove the camera.

6. Remove the license plate and camera before drilling.

ATTENTION: Before drilling any holes, remove the camera and the license plate and carefully examine the

area around and behind the installation position. Make sure that there are no parts that can be damaged

(especially electrical cables, components of the vehicle’s fuel system, or any liquid tanks). Please take every

reasonable precaution. Choose a drill that is suitable for the supplied grommet and material.

7. After drilling the hole, insert the supplied grommet and pass the camera cables through the

grommet into the vehicle.

8. Next, you’ll need to find the vehicles reversing light. To locate the reverse lights 12/24V (+) wire,

you may need to contact your vehicle manufacturer for wiring diagrams and use a multimeter to
determine the positive from the negative wire. Once you have done this, ensure your ignition is
turned off and the negative cable (ground -) of your battery is disconnected.

9. You will have to route the camera cables to the location of your reverse light wires. Securely fasten

the power cable to prevent it on being caught on any vehicle components such as the trunk hinge.
NEVER route the cable on the outside of the vehicle!

10. Connect the cameras positive wire to the positive (+) of the reverse lamp, and the negative wire to

the negative (ground) of the reverse lamp. Ensure that the wires are connected strongly.