VPAP™ Adapt
POSITIVE AIRWAY PRESSURE DEVICE
H5i™
HEATED HUMIDIFIER
Welcome Guide
English
Welcome
Thank you for choosing the VPAP Adapt or H5i. Before operating this device, please read the entire Welcome and Information Guides.
|
DC power inlet |
|
Module/Adapter port |
|
Air filter |
Air outlet |
SD card slot |
VPAP Adapt at a glance
The VPAP Adapt system comprises the following elements:
• VPAP Adapt device • Air tubing • 90W power supply unit • S9Travel bag • SD card • S9 SD card protective folder.
Optional components include:
• H5i heated humidifier • Standard air tubing • SlimLine air tubing • 3m air tubing • ClimateLine heated air tubing • ClimateLineMAX heated air tubing • 30W power supply unit (does not support H5i)
• Power Station II battery pack • DC/DC Converter 24V/90W.
Traveling with the VPAP Adapt
When traveling you may choose to leave behind your H5i and take your VPAP Adapt device only. If this is the case, ensure you pack the SlimLine, Standard or 3m air tubing in your travel bag, as the ClimateLine or ClimateLineMAX heated air tubing is not designed to connect directly to the VPAP Adapt device.
1 English
Flip lid seal
Flip lid
Air outlet
|
Release |
|
button |
ClimateLine or |
|
ClimateLineMAX |
|
connection port |
Latch |
|
H5i water tub |
H5i at a glance
The H5i system comprises the following elements:
• H5i heated humidifier • H5i water tub • ClimateLineMAX heated air tubing (if sold as a Climate Control Kit)
Optional components include:
• ClimateLine heated air tubing • H5i cleanable water tub.
Traveling tips
When moving or traveling with your H5i:
•Ensure that the water tub is empty.
•Disconnect the H5i from the VPAP Adapt by using the release button.
2
Setup
1.Align your H5i with your VPAP Adapt and push them together until they click into place.
2.Connect the DC plug of the power supply unit to the rear of the VPAP Adapt.
3.Connect the power cord to the power supply unit.
4.Plug the other end of the power cord into the power outlet.
5.Connect one end of the air tubing firmly onto the air outlet.
6.Connect the assembled mask system to the free end of the air tubing.
Notes:
•• For more information on assembling your mask see your mask user guide.
•• Recommended masks are available on www.resmed.com on the Products page under Service & Support.
3 English
Filling the water tub
1.Slide the latch and lift open the flip lid.
2.Remove the water tub.
3.Fill the water tub (through the center hole) with distilled or deionized water up to the maximum water level mark (380 mL).
4.Return the water tub to the H5i.
5.Close the flip lid ensuring that it clicks into place.
1 |
2 |
3 |
4 |
5 |
4