Remotec Z-Extender ZXT-300 Operating Instructions Manual
1
Z-ExtenderTM
ZXT-300
(
Z-Wave-to-IR Extender)
Operating Instructions
Introduction
ZXT-300 works with any Z-Wave compliant controller or gateway
translating Z-Wave’s Simple AV command to IR control code. User is
able to set the IR code and using the larger code library of ZXT-300. It
is capable to use the learning function of ZXT-300 through the simple
UI on gateway or Z-Wave remote controller. It is allow to download
the preset/learnt commands from gateway or Z-Wave remote controller
to ZXT-300. User can enjoy the fully wireless control in anywhere at
home.
Figure 1 ZXT-300
2
ZXT-300 Operations
Before using the ZXT-300, please read the [INSTALLATION] if it is
need to mount the ZXT-300 to a wall. Power up the ZXT-300 by the
supplied AC/DC adaptor.
L CAUTION
− Be sure to always use the supplied AC/DC adaptor.
− Do not try to power up other device with the supplied AC/DC
adaptor. This could damage the AC/DC adaptor or the
connected device.
Configurations
Figure 2 PROG Key and IR Ports of ZXT-300
IR
Learnin
g
LED
Indication
IR Port 1
IR Port
Out
p
ut
“PROG”
button
3
Change Z-Wave-to-IR Channel (EP) on ZXT-300
Step Setup Key
LED Indication Status
on ZXT-300
1
Press and hold PROG button on
the ZXT-300 for 3seconds to
switch the EP (1->2->3->4>5->6->1->2...)
• LED flashes 1 = EP1
• LED flashes 2 = EP2
• LED flashes 3 = EP3
• LED flashes 4 = EP4
• LED flashes 5 = EP5
• LED flashes 6 = EP6
How to get the NIF “Node Information Frame” on ZXT300
Step Setup Key
LED Indication Status
on ZXT-300
1
ZXT-300 switch to Z-Wave-toIR Channel (EP1)
• LED flashes 1 times
then keep on
2
Press the PROG button on the
ZXT-300
(EP1 will response “NIF”
EP2, EP3, EP4, EP5, EP6 will
response “Multi-channel
capability report”)
• LED flashes 1 times
then keep on
(ZXT-300 will report the
supported command
class)
Reset ZXT-300 to factory default
Press and hold “PROG” button for 10seconds on ZXT-300. LED will
flashing until reset process is completed.
Loading...