Warning: When the hair dryer is used in a bathroom,
unplug it after use since the proximity of water presents
a hazard even when the hair dryer is switched off.
When using electrical appliances, especially when
children are present, basic safety precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
DANGER – As with most electrical appliances, electrical
parts are electrically live even when the switch is off.
To reduce the risk of death by electric shock:
• Always unplug it immediately after using.
• Do not place or store an appliance where it can fall or be
pulled into a bath or sink.
• Do not use while bathing.
• Do not place or drop into water or other liquid.
• If an appliance falls into water, “unplug it” immediately.
Do not reach into the water.
For additional protection, the installation of a residual
current device (RCD) with a rated residual operating
current not exceeding 30mA is advisable in the electrical
circuit supplying the bathroom. Ask your electrical
contractor for advice.
WARNING – TO REDUCE THE RISK OF BURNS,
ELECTROCUTION, AND FIRE, OR INJURY TO PERSONS.
• An appliance should never be left unattended when plugged
in to a power outlet.
2
Page 3
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Keep the appliance and the power cord away from the
edge of table or countertops and out of reach of children and
persons with reduced physical, sensory or mental
capabilities.
• This appliance is not a toy. Children shall be supervised to
ensure they do not play with the appliance.
• Use this appliance only for its intended use as described in
this manual. Do not use attachments not recommended by
Remington.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agents or similarly qualified
persons in order to avoid a hazard.
• Do not use on people who are sleeping.
• Never drop or insert any object into any opening of this
appliance.
• Do not use outdoors or where aerosol (spray) products are
being used or where oxygen is being administered.
• Do not direct hot air towards the eyes or other heat sensitive
areas.
• Attachments, where provided, may be hot during and after
use. Allow them to cool before handling.
• When using the appliance, keep your hair away from the air
inlet grille. Do not let your hair get drawn into the appliance.
SAVE THESE INSTRUCTIONS
3
Page 4
AC2400AU SALON TURBO HAIR DRYER
Use & Care Instruction Manual
Thank you for purchasing your new Remington® Salon Turbo
hair dryer. Featuring a 2000 watt long lasting AC motor and
Tourmaline Ceramic Technology, this salon professional dryer
will help prevent frizz and add shine to your luscious locks.
1
3
2
KEY PARTS
1. Professional concentrator
2. Air outlet grille
3. Air inlet grille
4. Cool shot
5. Heat settings
Low heat
Medium heat
High heat
4
5
6
7
6. Speed settings
Off
Low speed
High speed
7. Hang loop
4
Page 5
TOURMALINE CERAMIC
Tourmalines are precious gemstones with highly unique properties.
Heating crushed tourmalines results in the powerful natural
emissions of ions and far-infrared heat. The Salon Turbo hair dryer
features Tourmaline Ceramic Technology with 4x more Tourmaline*
to provide a natural source of ions to reduce frizz and create a
smooth and shiny finish.
COOL SHOT
This hair dryer is equipped with a cool shot, which is used to hold
your hairstyle. Press and hold the cool shot button to rapidly cool
and hold your hair once it has been styled.
BASIC HAIR CARE INSTRUCTIONS
For optimal results, shampoo and condition your hair prior to
styling and towel dry to remove excess moisture.
QUICK DRYING
Select a high heat & speed setting and roughly dry your hair. Use
a brush or your hand to shake out excess moisture whilst drying
and keep the hair dryer in constant motion.
STRAIGHTENING
Select high heat and roughly dry the hair. When the hair is nearly
dry, attach the concentrator nozzle (which minimises frizz) and
reduce the heat & speed. Section the hair according to thickness
and begin with straightening bottom layers first. Using your
brush, follow the concentrator from above, while slowly gliding
down each section of hair from roots to tips. Once bottom layers
have been straightened, then straighten the mid section and
complete by straightening top layers.
NATURAL WAVY TEXTURE
Using a low heat/speed setting, ‘scrunch’ sections of hair with
*vs. standard Remington dryer
5
Page 6
your fingers into the palm of your hand while directing airflow
through your fingers. Once you have reached the desired effect,
use the cool shot on each section of hair to hold style. For more
volume lean forward and dry hair in the upside down position.
LIFT & VOLUME
Use the hair dryer on a low heat/speed setting, work from the
roots of hair and begin at the back of the head. Section your hair
and use a round brush to dry against the natural growth pattern
of your hair. This creates lift at the roots, which creates a style
with volume.
STYLING
Set the hair dryer to a low heat setting and attach the concentrator
nozzle for precision drying. Section the hair and style using a
round brush. Concentrate the airflow directly on the hair while
styling in the direction you desire. If necessary, hold the airflow
for 2-5 seconds on each section while curling under or over for
additional hold.
USER INSTRUCTIONS
This hair dryer is equipped with a thermostat that will cycle ‘OFF’
if the temperature exceeds the comfort level due to partially
blocked air inlet or air outlet openings. In the event that the hair
dryer stops during use turn off all switches and allow the hair
dryer to cool down, at which time the thermostat will automatically
reset. Before using again, check that the air inlet and air outlet
openings are not blocked. Unplug the hair dryer and clean the
openings if necessary. During use, do not block the air openings
or let your hair be drawn into the hair dryer.
MAINTENANCE
Your hair dryer is designed for household use and is virtually
maintenance free. No lubrication is needed. When cleaning
6
Page 7
becomes necessary, turn all switches off and disconnect the hair
dryer from the power outlet.
To maintain peak product performance, it is important to clean
the air inlet grille at the back of the hair dryer. To remove the air
inlet grille, grasp the air inlet grille retaining ring with your hand
and twist it anti-clockwise until it unlocks. Pull it away from the
hair dryer. It can now be cleaned with a soft brush or a vacuum
cleaner. Once clean, take the air inlet grille retaining ring and
position it so the lugs on the ring are aligned with the notches on
the side of the dryer. To lock, turn the air inlet grille retaining ring
clockwise. The exterior of the hair dryer can be cleaned by wiping
it with a damp cloth.
STORAGE
When not in use, always unplug the hair dryer from the power
outlet. Allow the hair dryer to cool and store out of the reach of
children in a safe dry place. Never wrap the power cord around
the hair dryer since this will cause the cord to wear prematurely
and break. Handle the cord carefully for long life and avoid jerking,
twisting or straining especially at the plug connections. If the cord
becomes twisted in use, periodically straighten it.
You may also use the hang loop to store the hair dryer within
convenient reach, ensuring that water cannot be splashed on to it
when it is hung up.
7
Page 8
WARNING: Do not use this appliance near bathtubs, showers, basins or
other vessels containing water.
As with all electrical appliances, the power cord must be regularly
checked for wear and tear. Immediately cease using this product if the
power cord shows any signs of damage.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
8
Page 9
Spectrum Brands Australia P ty Ltd and Spectrum Brands New Z ealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the
Competition and C onsumer Act 2010;
CGA means the New Zealand C onsumer Guarantees Act 199 3;
Goods means the product or equipment which was accompanied by this warrant y and purchased
in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand L imited,
as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorised distributor or retailer of the G oods that sold you the Goods
in Australia or in New Zealand; and
You means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or ref und for
a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and
remedies in respect of the Goods which the consumer has under either the
Australian Consumer Law or the CGA. The original purchaser of the Goods is
provided with the following Warranty subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the
period of three (3) years from the date of purchase (Warranty Period). If the Goods
prove defective within the Warranty Period by reason of improper workmanship or
material, we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Go ods be at tribut able
to misuse, abuse, accident or non-observance of manufacturer’s instructions on the
part of the user. As far as the law permits, the manufacturer does not accept liability
for any direct or consequential loss, damage or other expense caused by or arising out
of any failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutter s and foils) of the Goods are included
under this Warrant y only where there is a defect in workmanship or materials used.
6. The warrant y granted under clause 3 is limited to repair or replacement only.
7. Any part s of the Goods replaced during repairs or any product replaced remain the
proper ty of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same
date as for the Warranty Period on the original Goods which are replaced.
9
Page 10
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid freight
within the Warrant y Period accompanied with (i) the legible and unmodified original proof
of purchase, which clearly indicates the name and address of the Supplier, the date and
place of purchase, the product name or other product serial number and (ii) this warranty.
9. This warrant y is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Go ods have been serviced or other wise repaired by a per son not
authorised to do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to
any industrial or commercial use of the Goods. The Goods must be connected to the
electrical voltage requirements as specified in the ratings label located on the G oods.
11. This warranty does not cover the cost of claiming under the warranty
or transport of the Goods to and from the Supplier or us.
12. This warrant y is only valid and enforceable in Australia against Spectrum Brands
Australia Pt y Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Locked Bag 3004
Braeside, VIC 3195
AUSTRALIA
Customer service in Australia: 1800 623 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
PO Box 9817
Newmarket, Auckland 1149
NEW ZEALAND
Customer service in New Zealand: 080 0 736 776
E-mail: info@remington.co.nz