Wood Inserts
I1200 Small Wood Insert
Model I1200S
Cordwood BTU’s 55,000 BTU’s
EPA g/hr 3.0 g/hr
Flue Size 6” (152mm)
Unit with Standard Flue Adaptor
6" (152mm) Diameter
STANDARD FLUE ADAPTOR
Unit with Offset Flue Adaptor
6" (152mm) Diameter
OFFSET FLUE ADAPTOR
I1200 Wood Insert
Minimum Fireplace Opening Faceplate Dimensions
Height 19” (483mm) Standard 3 Sided 38” (width) x 26-1/8” (height)
Width 23” (584mm) Standard 4 Sided 38” (width) x 34-1/8” (height)
Depth
Standard Flue Adaptor
Depth
Offset Flue Adaptor
13-3/4” (349mm) Oversize 3 Sided 44” (width) x 30-1/8” (height)
16-1/2” (419mm) Oversize 4 Sided 44” (width) x 38-1/8” (height)
Wood Inserts
187June 2007 Regency Product Specifi cations Book
I1200 Wood Insert
I1200 Small Wood Insert
Dimension Description I1200
A Adjacent Side Wall (to side) 15” (381mm)
B Mantle (to top)** 20” (508mm)
C Top Facing (to top) 14” (356mm)
D Side Facing (to side) 7-3/8” (187mm)
E Minimum Hearth Extension* 16” (406mm)
F Minimum Heath Thickness* 1-1/2” (38mm)
G Minimum Hearth Side Extension 8” (203mm)
Wood Inserts
Side and Top facing is a maximum of 1-1/2" thick.
Floor protection must be non-combustible, insulating material with an
R value of 1.1 or greater.
* If the hearth extension is fl ush with the fl oor (F) it must extend
19-1/2" in front of the body face (E).
Note: Hearth Extension Width (G) is measured from edge of fuel
door to side of hearth.
** A non-combustible mantel may be installed at a lower height if the
framing is made of metal studs covered with a non-combustible
board.
Wood Inserts
188 June 2007 Regency Product Specifi cations Book
Loading...