Regency FireWizard User Manual

REMOTE CONTROL

OPERATING INSTRUCTIONS

For North American Electronic Units P40

918-619a 10/10/08

© Copyright 2008, FPI Fireplace Products International Ltd. All rights reserved.

Page 1 FPI FireWizardTM Remote Control Manual - IPI

WARNING

Shock Hazard

Can cause severe injury or death.

This device is powered with line voltage.

Do not try to open or repair the control box. There are no internal serviceable
parts.

CAUTION

Property Damage Hazard

Excessive heat can cause property damage.

The fireplace can stay ignited for many hours. Take care to turn off the fireplace if
it is left unattended by adult.

Keep remote control out of reach of children.

NOTE

Disabled Thermostatic Control

Thermostatic controls have been disabled to meet North American Standards.

This effects the following units: L676E & L900E

IMPORTANT!

The transmitter and receiver in this box must be coded together in order for the
remote control to function.

Please see the instructions under “Matching Remote Handset and Control
Box ID Code”, and follow the coding instructions carefully. Failure to code these
together will result in malfunction of the remote control.

FireWizardTM is a trademark of FPI Fireplace Products International Ltd. Printed in Canada

TABLE OF CONTENTS

Matching Remote Handset & Control Box ID Code.......................................................... 4

Remote Control Keypad ..................................................................................................... 5

Remote Control Screen Display (LCD).............................................................................. 6

Basic Functions................................................................................................................... 7

Switching the Remote ON and OFF .............................................................................. 7

Setting Time & Day ...................................................................................................... 7

Displaying Temperature in Celsius or Fahrenheit ........................................................ 8

Flame Height Adjustment.............................................................................................. 8

Operation during Power Outage ......................................................................................... 9

Battery Replacement........................................................................................................... 9

1.1.1.

Page 3 FPI FireWizardTM Remote Control Manual - IPI

Matching Remote Handset and Control Box ID Code

The Remote Control Handset has a set of unique ID codes that is pre-programmed into its
memory. This set of ID codes helps to differentiate one Remote Control Handset from
another so that only the control box with a matching ID code will respond to the
appropriate Remote Control Handset.

To ensure the remote control is matched to the receiver correctly, please follow the steps
below:

Install the 2 x AAA alkaline batteries into the Remote Control.

1.

Unplug and re-plug the power cord. The power cord is located on the left hand side of

2.

the appliance and will be plugged into the receptacle.

Press and hold the PROG and FAN buttons simultaneously for up to 20 seconds.

3.

During this time, the remote will display LC while it is transmitting codes to the
receiver.

Once it is successfully transmitted, wait for 20 seconds and press the ON/OFF button

4.

on the remote control once and the burners will come on.

If is does not work the first time, repeat steps 2 and 3.

The remote control is now programmed to the receiver and the appliance can now be

5.

operated with it.

The control box will only learn the Remote ID codes during the first 30 seconds after
power is applied and will ignore this special command from the Remote after the first 30
seconds.

NOTE: This must only be performed by a qualified installer.

Page 4 FPI FireWizardTM Remote Control Manual - IPI