Reese 63034 User Manual

Installation Instructions

SAFETY CHAIN KIT

1

Part Number:

63034

DESCRIPTIONQTYITEM

72” SAFETY CHAIN WITH “S” HOOKS – BOTH ENDS11

1. CONNECT THE SAFETY CHAIN TO TRAILER.

2. CROSS THE TWO ENDS OF THE CHAIN UNDER THE COUPLER AND CONNECT TO CHAIN BRACKET ON HITCH.

LOOP THE CHAINS THROUGH THE CHAIN BRACKET AS SHOWN AND CONNECT THE “S” HOOKS THROUGH A LINK IN
CHAIN SUCH THAT THE HOOK HANGS DOWN.

ALLOW ONLY ENOUGH SLACK TO PERMIT TURNING.

DO NOT CONNECT THE “S” HOOKS DIRECTLY TO THE HITCH CHAIN BRACKET.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.

z 2006 Cequent Towing Products

Rev. A9-20-0663034NSheet 1 of 1