Reese 61302 User Manual
Installation Instructions
(LB)
(LB)
g
()
()
y()
g
4
1
Venture CJ13517
SidewinderTMTurret
DEALER/INSTALLER:
(1) Provide this Manual to end user
END USER:
(1) Read and follow this Manual for Sidewinder Turret Installation.
(2) Save this Manual for Future Reference.
(3) For Sidewinder Arm Installations, Refer to Arm Installation Manuals.
Part Number:
61302
Turret Shown Assembled With Arm
(4) Pass on copies of Manual to any other users or owner.
Note: These Instructions Are Only For Installation Of Turret Into Wing Sets.
You Should Refer To The Installation Instructions For Your Sidewinder Arm.
Equipment Required:
Fastener Kit: 61302F
Wrenches: 15/16”
Drill Bits: Not Required
Torque Wrench
Qty. (1) Turret 61302 (Formally ST300)
1
Qty. (1) Upper Wear Plate
2
Qty. (1)Bushin
3
Qty. (1) Hardware Kit
4
INDEX
1. GUIDELINES FOR MATCHING WING SET P. 1-2
2. ASSEMBLY INSTRUCTIONS P. 2
3. 5 YEAR LIMITED WARRANTY P. 3
Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating,
Trailer Manufacturer’s Rating or
Max Gross
Trailer WT
16,000 LB 3,200 LB
Max Pin
WT
Figure 1
2
3
Matching Wing Sets
Figure 2
Trailer Forward
WARNING:
Failure to follow all of these instructions may result in death or serious injury!
2009 Cequent Performance Products, Inc Sheet 1 of 3 61302IN 5/3/2011 Rev. A
For Wing Set Make and Model Numbers:
Venture CJ13515
Venture CJ20517
M-Tec RVPN1409 (Note Rating)
Use The Bolt Hole Locations Noted By The “A”
The pattern is a 8” horizontal & a 1 1/2” vertical
Form: F205 Rev A 5-6-05
Figure 3
Hard
Kit Contai
Trailer Forward
ware
Item#
1) (12) ½”-13x2 Grade 8 Bolts
2) (12) ½”-13 Grade 8 Nuts
3) (12) ½” Flat Washers
4) (12) ½” Conical Lock Washers
ns:
Installation Instructions
SidewinderTMTurret
Matching Wing Sets
For Wing Set Make and Model Numbers:
Dexter 221-0033-00
Dexter 221-0031-00
Use The Bolt Hole Locations Noted By The “B”
The pattern is a 7” horizontal & a 1 1/2” vertical
Typical Bolting
Bolts & Flat Washers Are Installed From The Outside, Conical Lock Washers and Nuts On the Inside.
Torque All To 150 ft. lbs. Install as many bolts as the hole pattern will allow. That should be 5 or 6 per side.
(2) 1/2-13 Gr.8 Nut
(4) 1/2 Conical Lock Washer
Typical Wing
(3) 1/2 Flat Washer
(1) 1/2-13x2 Gr.8 Bolt
2009 Cequent Performance Products, Inc Sheet 2 of 3 61302IN 5/3/2011 Rev. A
Form: F205 Rev A 5-6-05
Loading...