Reese 38124 User Manual
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: N/A
Wrenches: 15/16”
Drill Bits: None
Chassis
Hitch
Installation Instructions
25K HITCH
Drawbar Kit:
38124B
Drawbar must be used in the
Drop position only.
Chassis
Part Numbers:
38124N
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
25,000 LB (11340 Kg) Max Gross Trailer Weight
4,000 LB (1814.4 Kg.) Max Tongue Weight
1.25
.25
2” – 2.5”
16.8”
8.3”
1111
2222
3333
4444
2222
3333
8888
26.2”
FRONT OF CHASSIS LOOKING REARWARD
7777
Both Sides
.25
14.5
6.5”
13.7”
5555
Slide hitch
against chassis.
6666
25.5”
4444
5555
3/4” Hitch Pin with Lanyard Qty. (1)
ClipQty. (1)
DrawbarQty. (1)
Hex Nut (5/8” – 11 Grade 8)Qty. (8)
1111
5555
6666
7777
8888
DRIVERS SIDE OF CHASSIS LOOKING AT
THE PASSENGER SIDE
Conical Washer 5/8”Qty. (16)
Hex Bolt (5/8” – 11 x 2” Grade 8)Qty. (8)
Spacer PlateQty. (2)
HitchQty. (1)
1. Measure chassis width. If chassis width is under 34.75” then remove shim plates(Item 7). To remove shim plates: remove
fasteners (Item 4, 5 & 6). Discard spacer plates (Item 2). Reinstall fasteners and align side brackets. Snug up fasteners.
2. Raise hitch into position. Weld hitch to chassis as shown above.
3. Torque hitch fasteners (Items 4,5 & 6) to:
Tighten 5/8” – 11 Grade 8 fasteners to 190 lb.-ft. (257.6 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2007 Cequent Towing Products
Form F206 Rev A 5605
Rev. B9-18-0738124NSheet 1 of 1
Loading...