Reese 38023 User Manual
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: N/A
Wrenches: 15/16”
Drill Bits: None
5
Chassis
Hitch
Installation Instructions
20K HITCH
Drawbar Kit:
38124B
Drawbar must be used in the
Drop
position only.
Chassis
Part Numbers:
38023N
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
20,000 LB (9072 Kg) Max Gross Trailer Weight
3,000 LB (1360.8 Kg.) Max Tongue Weight
.25
1.5” – 2.5”
27.0”
15.7”
4.8”
2
3
Qty. (1) 3/4” Hitch Pin with Lanyard
1
Qty. (1) Clip
2
Qty. (1) Drawbar
3
Qty. (8) Hex Nut (5/8” – 11 Grade 8)
4
6
4
5
7
1
Both Sides
Both Sides
Wrap Weld
Around Fillet
5
6
7
FRONT OF CHASSIS LOOKING REARWARD
13.7”
10.5”
.25
20.9”
.25
Qty. (16) Harden Washer 5/8”
Qty. (8) Hex Bolt (5/8” – 11 x 2” Grade 8)
Qty. (1) Hitch
1.00
DRIVERS SIDE OF CHASSIS LOOKING AT
THE PASSENGER SIDE
6.5”
Slide hitch
against chassis.
1. Measure chassis width. If chassis measurement is greater than 34.50 inches then loosen hitch fasteners (Items 4,5 & 6)
2. Raise hitch into position. If fasteners were loosen, torque hitch fasteners (Items 4,5 & 6) while hitch is in position.
3. Weld hitch to chassis as shown above.
4. Check Torque on hitch fasteners (Items 4,5 & 6) to:
Tighten 5/8” – 11 Grade 8 fasteners to 190 lb.-ft. (257.6 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with atorch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z 2007 Cequent Towing Products
Sheet 1 of 1 38023N 9-24-07 Rev. B
Form F206 Rev A 5605
Loading...