Reese 36007 User Manual

You can take it with you.
INSTALLATION INSTRUCTIONS
CHEVROLET & GMC
ELKHART, IN., OAKVILLE, ONT.
Product No.
36007
SMALL PARTS
PACKAGE 36566
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.
B
M
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH
G
L
IMPORTANT NOTES
TOOLS REQUIRED
M18 SOCKET 3/4” SOCKET 3/4” WRENCH TORQUE WRENCH
H
I
J
C
CENTER SECTION “A”
F
E
D
1. With factory installed bumper, remove rear bolt in frame to bumper bracket. attach left side bracket “B” and right side bracket “C” to the frame with the flanges out using existing holes in the frame. Install M12 bolts “M” , 1/2” carriage bolts “G” with
bolt plates “L”, serrated washers “H”, lock washers “I”, and nuts “J” as shown on each side. Leave nuts slightly loose. (On units without factory bumper brackets, install carriage bolt “G”, bolt plate “L” at rear the same as front and center bolts.
2. Assemble center section “A” to left and right side brackets “B” and “C” with six 1/2” hex head bolts “F”, lock washers “E”,
and nuts “D”. Alternatly tighten nuts until bolt heads seat.
3. Center hitch on the frame and tighten bolts and nuts in the frame.
Torque M12 bolts to 70 lb*ft. Torque 1/2” nuts to 70 ft*lb.
(OVER)
For Installation Assistance or Technical Help, Call 1-800-758-0869
36007IN-1APR98F PCN4040 © 1998 REESE PRODUCTS, INC. Litho in USA
For Installation Assistance or Technical Help, Call 1-800-758-0869
THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATION AND REQUIREMENTS FOR THE STATE OF NEW YORK AND VESC REGULATION V-5 FOR CONNECTING DEVICES AND TOWING SYSTEMS. WEIGHT DISTRIBUTING HITCH RATING IS 10000LB. MAX. GROSS TRAILER WEIGHT AND 1000 LB. MAX. TONGUE WEIGHT. WEIGHT CARRYING HITCH RATING IS 5000LB MAX GROSS TRAILER WEIGHT AND 500 LB MAX TONGUE WEIGHT. CONSULT VEHICLE OWNERS MANUAL FOR TOWING RECOMMENDATIONS AND LIMITATIONS.
Reese warrants its Hitches, custom Hitch Receivers, and Sway Controls from date of purchase against defects in material and workmanship under normal use and
LIMITED WARRANTY
service, ordinary wear and excepted, for the ownership life of the original consumer purchaser. Reese will replace FREE OF CHARGE any part which proves defective in material or workmanship when presented to any Reese dealer, Reese Warehouse or return to factory. TRANSPORTATION CHARGES PREPAID, at the address below. THIS WARRANTY IS LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage to the Hitch, Custom Hitch receiver or Sway Control as a result of misuse, abuse, neglect, accident, improper installation, or any use violative of instructions furnished by us, WILL VOID THE WARRANTY. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem Reese warrants its Hitches, Custom Hitch Receivers and Sway Controls from date of purchase against defects in material and workmanship under normal use and service, ordinary wear and tear excepted, for the ownership life of the original consumer purchaser. with warranty service or performance, you may be able to go to a small claims court, a state court, or a federal district court.
Reese Products, Inc. 51671 State Road 19-N Elkhart, IN 46514
36007IN-1APR98F PCN4040 © 1998 REESE PRODUCTS, INC. Litho in USA
Reese Products of Canada, Ltd. 475 Wyecroft Road Oakville, Ontario Canada L6K2H2
Loading...