Reese 35365 User Manual

REESE
INSTALLATION INSTRUCTIONS
Product No.
35365
You can take it with you.
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.
1/2" RIB NECK BOLT
ELKHART, IN., OAKVILLE, ONT.
1/2" SERRATED WASHER
1/2" LOCK WASHER
1/2" NUT
SMALL PARTS
PACKAGE 36634
IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH
TOOLS REQUIRED
9/16" SOCKET 9/16" WRENCH 3/4" WRENCH 3/4" SOCKET TORQUE WRENCH
1/2" CARRIAGE BOLT
BOLT PLATE
CENTER SECTION
3/8" SERRATED WASHER
1. Remove the two lower bumper support brackets, one per side; save the bolts and washers. Save the bracket and return to the owner.
2. Place the left and right side brackets against the frame bottom. Install four 1/2" bolts removed in step one. Leave the bolts loose.
3. Install the center section between the side brackets and install six 1/2" rib neck bolts, lock washers and nuts on the bolts. See the diagram above.
(OVER)
1/2" HEX BOLT
3/8" LOCK NUT
1/2" LOCK WASHER
1/2" NUT
For Installation Assistance or Technical Help, Call 1-800-758-0869
35365IN-1SEP97M PCN3666 © 1997 REESE PRODUCTS, INC. Litho in USA
4. Install two 3/8" bumper bolts (removed in step one), two 3/8" serrated washers, and two 3/8" lock nuts (from the parts package). Leave the lock nuts loose at this time.
!WARNING!
Two 3/8" lock nuts must be used with two 3/8" bumper bolts; otherwise the receiver could
loosen and separate from the vehicle.
5. Screw the pull wire (55392) onto a 1/2" carriage bolt. Feed the pull wire through a bolt plate and the large hole in the outboard side of the frame. Pull it out the bottom hole of the frame. Repeat for the other side. Install two 1/2" serrated washers, lock washers and nuts on the bolts. Leave the nuts loose at this time.
6. Tighten bolts and nuts in the exact order listed; this allows the receiver to be pulled rearward to the bumper before the frame bolts are tightened. *Alternately tighten the six nuts on the rib neck bolts. *Torque those six 1/2" nuts to 75 ft.*lb. *Torque two 3/8" lock nuts on the bumper to 30 ft.*lb. *Torque the remaining 1/2" nuts to 75 ft.*lb.
For Installation Assistance or Technical Help, Call 1-800-758-0869
THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATION AND REQUIREMENTS FOR THE STATE OF NEW YORK AND VESC REGULATION V-5 FOR CONNECTING DEVICES AND TOWING SYSTEMS. WEIGHT DISTRIBUTING HITCH RATING IS 10000 LB. MAX. GROSS TRAILER WEIGHT AND 1000 LB. MAX. TONGUE WEIGHT. WEIGHT CARRYING HITCH RATING IS 5000 LB MAX GROSS TRAILER WEIGHT AND 500 LB MAX TONGUE WEIGHT. CONSULT VEHICLE OWNERS MANUAL FOR TOWING RECOMMENDATIONS AND LIMITATIONS.
LIMITED WARRANTY
Reese warrants its Hitches, custom Hitch Receivers, and Sway Controls from date of purchase against defects in material and workmanship under normal use and service, ordinary wear and excepted, for the ownership life of the original consumer purchaser. Reese will replace FREE OF CHARGE any part which proves defective in material or workmanship when presented to any Reese dealer, Reese Warehouse or return to factory. TRANSPORTATION CHARGES PREPAID, at the address below. THIS WARRANTY IS LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage to the Hitch, Custom Hitch receiver or Sway Control as a result of misuse, abuse, neglect, accident, improper installation, or any use violative of instructions furnished by us, WILL VOID THE WARRANTY. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem Reese warrants its Hitches, Custom Hitch Receivers and Sway Controls from date of purchase against defects in material and workmanship under normal use and service, ordinary wear and tear excepted, for the ownership life of the original consumer purchaser. with warranty service or performance, you may be able to go to a small claims court, a state court, or a federal district court.
Reese Products, Inc. 51671 State Road 19-N Elkhart, IN 46514
35365IN-1SEP97M PCN3666 © 1997 REESE PRODUCTS, INC. Litho in USA
Reese Products of Canada, Ltd. 475 Wyecroft Road Oakville, Ontario Canada L6K2H2
Loading...