Reese 33056 User Manual

INSTALLATION INSTRUCTIONS

DURANGO

PLYMOUTH, MI

Product No.

33056 37037

SMALL PARTS

PACKAGE 37600

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY

OCCUR DUE TO OVER TIGHTENING.

WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

1/2” SERRATED WASHER

1/2-13 HEX BOLT

USE ONLY TOWING PRODUCTS SUPPLIED OR APPROVED BOLTS, LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH

1/2” CARRIAGE BOLT

BOLT PLATE

IMPORTANT NOTES

TOOLS REQUIRED

3/4” SOCKET TORQUE WRENCH

1/2” NUT

BLOCK

1/2” KNURLED BOLT

1/2” NUT

1/2” LOCK WASHER

1. Insert a hex bolt and a block through the holes in the bottom of the rear crossmember. Also insert a carriage bolt and bolt plate into the rear hole of the mounting structure that the passenger side shock absorber mounts to. This is between the frame and the spare tire.

2. Lift the brackets up in place under the vehicle with the bolt coming through the holes. See the diagram above. Install 1/2” serrated washers, lock washers and nuts on the on the bolts.

3. Install a carriage bolt and bolt plate into the hole in the frame and hitch bracket on the drivers side. Install a 1/2” serrated washer, lock washer and nut on the bolt.

4. Install the 1/2” knurled bolts, 1/2” lock washers, and the 1/2” nuts. Tighten the nuts until the bolt heads seat against the brackets.

5. Torque all 1/2” nuts to 70 ft*lb.

(OVER)

THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATION AND REQUIREMENTS FOR THE STATE OF NEW YORK AND VESC REGULATION V-5 FOR CONNECTING DEVICES AND TOWING SYSTEMS. WEIGHT DISTRIBUTING HITCH RATING IS 7500 LB. MAX. GROSS TRAILER WEIGHT AND 750 LB. MAX. TONGUE WEIGHT. WEIGHT CARRYING HITCH RATING IS 5000 LB MAX GROSS TRAILER WEIGHT AND 500 LB MAX TONGUE WEIGHT. CONSULT VEHICLE OWNERS MANUAL FOR TOWING RECOMMENDATIONS AND LIMITATIONS.

LIMITED WARRANTY

Towing Products warrants its Hitches, custom Hitch Receivers, and Sway Controls from date of purchase against defects in material and workmanship under normal use and service, ordinary wear excepted, for the ownership life of the original consumer purchaser. Towing Products will replace FREE OF CHARGE any part which proves defective in material or workmanship when presented to any Towing Products dealer, Towing Products Warehouse, or returned to factory, TRANSPORTATION CHARGES PREPAID, at the address below. THIS WARRANTY IS LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage to the Hitch, Custom Hitch receiver or Sway Control as a result of misuse, abuse, neglect, accident, improper installation, or any use violative of instructions furnished by Towing Products, WILL VOID THE WARRANTY. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem with warranty service or performance, you may be able to go to a small claims court, a state court, or a federal district court.

Towing Products PO Box 8102 47774 Anchor Ct. Plymouth, MI 48170

Towing Products 2351 Winston Park Drive Oakville, Ontario Canada L6H6R7