Reese 33006 User Manual
SERIES 51®
Bumper
Installation Instructions
Jeep Grand Cherokee
Part Numbers:
51010
33006
44093
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51010-051
Wrenches: 18mm, 19mm
Drill Bits: None
Hitch
Center holes in hitch
about base of studs
Fascia
Wiring Access Location: SUV3, SUV4
Fasteners typical both sides
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Existing weldnut
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Max Gross
Trailer WT (LB)
Clearance hole
Max Tongue
500 (227 Kg)5000 (2270 Kg)
300 (136 Kg)3500 (1589 Kg)
Existing studs
2
1
WT (LB)
2
Figure 2
Typical both sides, all Models
1
2
1. Vehicles equipped with closed side fuel tank shield, must have shield supported because shield is secured by fasteners
which will be removed in Steps 2 & 3.
2. Remove nuts and flat washers from the two studs at the end of the frame and discard.
3. Remove bolts and washer assembly from forward attachment and discard.
4. Raise hitch into position over two existing studs at the end of the frame. Being careful to center the holes in the hitch around
the base of the studs. As shown in Figure 2. Loosely install conical washers and nuts supplied, both sides, as shown in
Figure 1.
Fuel tank shield will be sandwiched between frame and hitch side brackets.
Note:
5. Install hex bolt, conical washer into existing weldnut at forward attachment.
Note: 3/4 diameter hole is for clearance and does not require a fastener.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Hex Bolt M12 X 1.75 X 40Qty. (2)
Conical Washer 1/2Qty. (6)
Tighten all fasteners with torque wrench to 55 Lb.-Ft. (75 N*M)
3
Hex Nut M12 X 1.75Qty. (4)
Figure 1
3
z 2001, 2002, 2006 Cequent Towing Products
Rev. A6-27-06N51010Sheet 1 of 1
Form: F205 Rev A 5-6-05
Loading...