Reese 30154 User Manual

INSTRUCTIONS

REESE 5THWHEEL HITCH MOUNTING ADAPTER KIT FOR

CHRYSLER UNDERBED MOUNTING SYSTEM #30154

SAE J2638 RATED TO 25,000LB GROSS TRAILER WIEGHT

DEALER/INSTALLER:

1. Provide this Manual to end user.

2. Physically demonstrate mounting and un-mounting procedures in this Manual to end user.

3. Have end user demonstrate that he/she understands procedures.

END USER:

1.Read and follow this Manual every time you use adapter.

2. Save this Manual for future reference.

3. Pass on this manual to any other user or owner of adapter.

4. Never remove adapter warning decals . If damaged, contact Cequent Performance Products, Inc. (1-888-521-0510) for free replacement.

REF # QTY. DESCRIPTION

1 (1) ADAPTER WELDMENT

2 (2) REAR HD TEE-PIN ANCHOR

3 (2) FRONT TEE-PIN ANCHOR

4 (4) ANCHOR BUSHING

5 (4) ANCHOR HANDLE

6 (4) 1” JAM NUT

7 (4) COTTER PIN

8 (4) END CAP

9 (2) BAIL PIN

10 (1) REAR FACING REESE LABEL

For Installation Assistance or Technical Help, Call 1-888-521-0510

If this adapter used to tow anything over 20,000lbs it is

REQUIRED that the included Heavy Duty bolts are used

instead of the standard attachment pins and spring

clips

SHEET 1 OF 5

30154N 06-24-13 Rev. A

WARNING:

Failure to follow all of these instructions may result in death or serious injury

INDEX

1. SYSTEM ASSEMBLY P. 2 2. SYSTEM ADJUSTMENT P. 3

3. INSTALLATION P. 4 4. REMOVAL P. 4

5. BEFORE EACH TRIP/LUBRICATION P. 4 6. LIMITED LIFETIME WARRANTY P. 5

SYSTEM ASSEMBLY

REQUIRED TOOLS

• 1 ½” CLOSED END WRENCH

• NEEDLE NOSE PLYERS

• RUBBER MALLET

TEE PIN AND BUSHING ASSEMBLY

The anchor bushing is passed through the fore-aft tube, aligning the flat edge in the tube with the flats in the bushing. Then the 1” jam nut is threaded on to the anchor bushing to a point where there is no more vertical motion allowable and then another quarter

turn of the nut. The Tee pin anchor is then passed through the anchor bushing and the anchor handle is threaded on to the tee pin.

It is important to note both larger, Heave Duty tee pins are in the rear of the adapter, the rear of the adapter has a REESE

label facing outward.

Once the tee pin anchor is set at the correct height a cotter pin is passed through the slot in the anchor handle and the hole in the

tee pin anchor. Finally the end cap is installed with the ribs being inserted into the fore-aft tube.

ANCHOR HANDLE

1” JAM NUT

FORE-AFT TUBE

COTTER PIN

END CAP

ANCHOR BUSHING

FIG 2a

HD TEE PIN ANCHOR

(MATCHING SCALE)

TEE PIN ANCHOR

FIG 2b

FIG 1

TEE PIN ANCHOR

SHEET 2 OF 5

(MATCHING SCALE)

30154N 06-24-13 Rev. A

+ 3 hidden pages