Reece Milli Pure User Manual

MILLI PURE VERTICAL SINGLE HEATED
TOWEL RAIL 900X38 - CHROME

60

900

page 1 of 5

SPECIFICATIONS

Recommended use

Material

Electrical Connection

Power Entry

Heating Method

Wattage

IP Rating

Standard

Robe Hook

38

ø

Domestic, hotel and commercial

Copper Tube with Brass fittings

Hardwired only

Through wall bracket - Bottom Only

Water Filled

30 watts

IPX5

AS/NZS: 3350

Sold seperately

Dimensions are nominal measurements only.

To see the complete MILLI range go to
www.reece.com.au/bathrooms

CLEANING RECOMMENDATIONS

We recommend the use of a soft dry cloth.

This product should not be cleaned with abrasive materials or cleaning agents.

Damage caused by improper treatment is not covered by the product warranty - refer
to warranty conditions.

Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/
distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal
measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility
for printing errors.

Tech Page Version 1

page 2 of 5

MILLI PURE VERTICAL SINGLE HEATED
TOWEL RAIL 900X38 - CHROME

WARNING

This product must be installed by a qualified electrician in accordance with AS/NZS 3000 wiring rules. Switch off the electrical
supply at the mains before installation and maintenance. A means of disconnection must be incorporated in the fixed wiring
in accordance with the wiring rules. Suitable for bathroom and non-bathroom/dry areas. Not suitable for above baths, nor
for installation in saunas, steam rooms or shower cubicles. Please consult with a qualified electrician to confirm appropriate
compliant installation location.

Do not connect to a plug and socket outlet. Rated IPX5 and suitable for indoor use only. Do not fix to damp or conductive
surfaces. Site well away from curtains and fabrics. Switch off after use. Do not leave on for prolonged periods. This appliance is
not to be used by persons (including children) with reduced physical, sensory or mental capabilities.

INSTALLATION INSTRUCTIONS

Please consult with a qualified electrician to confirm appropriate compliant installation location.

Power Entry:

Power cable if hung vertically must always be positioned at the bottom, never at the top.

If hung horizontally it can be installed with the cable on either side.

MILLI PURE VERTICAL SINGLE HEATED
TOWEL RAIL 900X38 - CHROME

page 3 of 5

Fig 1.

Brass Bracket Insert - Close Up

8mm Wide
Channel

WALL

22mm

30 mm

Hold Towel Rail in desired position against wall, with a pencil
draw an outline around both bracket arms.

Fig 1.

Take brass bracket insert and place against wall in outlined circle.
Feed wall cable through wall mount channel. Using a
pencil mark the screw hole position and cross it for accuracy.
Mark screw hole for second brass bracket insert.

Fig 2.

Drill screw holes for both brackets, insert nylon plug into wall (if applicable).
If tiled wall installer MUST use a DIAMOND HEAD drill bit. Position wall
bracket so that GRUB SCREW HOLES face inwards.

Fig 2.

A qualied electrician must then connect towel rail element to

existing wall cable.

Fig 2.

1

Screw

WALL

1

Screw

Cord

Please ensure that the measurements are taken
accurately and that the screw is in a stud or noggin to
provide support. DO NOT overtighten screws.

Please ensure a DIAMOND HEAD drill bit is used to drill
screw and cord holes into tiled wall.

Hydrotherm take pride in the fact that all rails are
individually hand made. Due to this fact some
measurements may not be exact. PLEASE READ
INSTRUCTIONS CAREFULLY and do not force towel rail
into bracket if position of wall ange is not accurate.

Fig 3.

Fig 4.

WALL

WALL

Screw

Cord

Place Towel Rail in correct position over mounted brackets, secure unit in place by tightening grub screw on inside of
each bracket arm with Alan key provided. Fig 3. and Fig 4.

DO NOT OVERTIGHTEN SCREW - LEAVE SLIGHT
ADJUSTMENT OF THE FLANGE (SLACK) TO ENABLE
MOVEMENT WHEN THE TOWEL RAIL IS POSITIONED.

TOWEL RAILS MUST ALWAYS BE INSTALLED WITH THE ELECTRIC ELEMENT
POSITIONED AT THE BOTTOM OF THE UNIT FOR CORRECT HEAT TRANSFER

CLOSE UP

50mm

70mm

MILLI PURE VERTICAL SINGLE HEATED

Hydrotherm advise that the unit be removed from the wall and turned upside down to ensure that water does not spill.

TOWEL RAIL 900X38 - CHROME

REPLACING ELEMENT

Replacing an old element is a very simple process. All electrical wiring must be carried out by a licensed electrician.

There are Six Basic Steps:

1. You will need to obtain a 22mm tap spanner. Remove towel rail from brackets (if already installed).

2. On the side with the element cable remove push-on cap, and pull element cable through end.

3. Feed cable through spanner until you reach element hex nut.

4. Loosen element with spanner and remove.

5. Insert new element and screw in place with spanner until tight.

page 4 of 5

6.

Feed element cable back through bracket hole, and ret push-on cap. Towel Rail is now ready be re-installed.

Please note:

Ensure element always remains at bottom of Towel Rail if being installed vertically.

- 22mm Tap Spanner

Step 1.

Step 2.

Step 3.

Step 4.

Step 5.

Step 6.

MILLI PURE VERTICAL SINGLE HEATED
TOWEL RAIL 900X38 - CHROME

HARD WIRING

Hydrotherm recommends that all hard-wired heated towel rails be connected to a light switch
or timer.
Connecting hard-wired heated towel rails to a light switch or timer will prolong the life of the
electric element and reduce energy consumption.
Hydrotherm recommend the brand HPM and the model XLP770TRT, this particular unit is
designed specically for heated towel rails that is incorprated into a light switch panel.

page 5 of 5

TOWEL RAILS MUST ALWAYS BE INSTALLED WITH THE ELECTRIC ELEMENT
POSITIONED AT THE BOTTOM OF THE UNIT FOR CORRECT HEAT TRANSFER

Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference