Reece KADO RFH31WH, KADO RFH31BL Installation Instructions Manual
Installation Instructions
Kado Lux 3-in-1 Fan Heater, Light and Exhaust
Please read these instructions carefully before installing and using the product. Keep the instructions handy for future reference.
Electrical wiring must only be done by a licensed electrician and a “Certicate of Compliance” must be issued on completion of the
installation.
OPERATING INSTRUCTIONS AND HELPFUL HINTS
Fan
Please note: ‘Fan’ must be switched on before Heat function can operate.
• Use ‘Fan’ only (without ‘Heat’) for cooling effect in warmer weather.
EXHAUST LIGHT
Heat
Please note: ‘Heating Functions’ will only operate after ‘Fan’ has been switched on.
• Stand directly underneath the fan heater for maximum heating effect.
• In cooler weather, turn the heater on 5 to 10 minutes before having a bath or shower. This will warm the
environment, helping to minimise steam production and condensation on the mirrors and walls.
• In high steam conditions, use the exhaust function in tandem with the heat function to maximise steam
removal.
Exhaust
• For maximum exhaust performance, there must be sufcient replacement intake air available through either an ajar door, an
adequate size gap underneath the door or an air vent in the door.
• In high steam conditions, run exhaust for several minutes after leaving the bathroom to help with condensation and moisture control.
FAN
HEAT I HEAT II
WHAT’S IN THE BOX
• Bathroom unit
• Operating and Installation Instructions
• Five Switch Wall Plate
• Cutout Template
SAFETY INSTRUCTIONS
During use of the product, it is necessary to observe some precautions. Improper operation with disregard of precautions may result in
iniction of harm to health of the user and other people, as well as iniction of damage to their property.
• Use only the voltage specied on the rating plate of the heater.
• This item should only be installed by a licensed tradesperson.
• The heater should be connected to the electric mains equipped with an automatic circuit breaker.
• The unit must be handled with care avoiding any sudden impacts or vibrations.
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR POSITIONED CLOSE TO
CURTAINS OR OTHER COMBUSTIBLE MATERIALS.
• Do not use the appliance in areas where gasoline, paint or other ammable liquids are used or stored.
• Do not use the appliance in dusty areas or where explosives are stored.
• Do not use the appliance in a building site, green house, barn or in animal stables.
• Do not use the appliance as a sauna heater.
• Warning: To avoid risk of burns, do not touch the appliance while in operation or until fully cooled following operation (up to 1 hour).
Electricians, please ensure a copy of the Installation
Instructions are left with the end user for future reference
Page 1 of 5
Installation Instructions
Kado Lux 3-in-1 Fan Heater, Light and Exhaust
• Do not place any items of clothing, hand towels or similar over the heater to dry. Risk of overheating and re hazard.
• Do not leave the heater unattended whilst in use.
• If the heater is defective, it must be checked and repaired by the manufacturer, its service agent or similarly qualied persons for
repair.
• Do not operate appliance with wet hands.
• Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause re,
electric shock or injury.
• Do not use abrasive cleaning products on this appliance. If the body becomes dirty, wipe off dust with a cloth. Always disconnect
from the mains supply before cleaning.
• The heater must be installed at least 2.0m above the oor.
• The heater must not be located immediately below a socket outlet. The heater must not be located in front of a socket outlet. They
should be located outside the physical footprint of the units to minimize heat build up behind the heater.
• Do not connect the appliance to the mains source until it has been installed in its nal location and adjusted to the position it will be
used in.
• Do not operate with the cord coiled up as this could cause a buildup of heat, which could pose a hazard.
• Do not allow cord to come in contact with heated surfaces during operation.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance
• The appliance is only intended for the purpose described in user manual.
• Do not use appliance or any part of the appliance out of the intended use to avoid risk.
• The use of attachments which are not recommended or sold by the appliance manufacturer may cause a risk of injury to persons
• CAUTION — some parts of this product can become very hot and cause burns. Particular attention has to be given where children
and vulnerable people are present.
• Install and operate the heater in strictly horizontal position on the ceiling or ceiling structural surface. The thermal resistance of the
ceiling coating and ceiling material should be at least 80 °C.
• WARNING: This heater is not equipped with a device to control the room temperature. The heater must not be within reach from
the oor, as severe burns may occur due to high surface temperatures. Do not use this heater in small rooms or where the room or
area is occupied by persons not capable of leaving the room on their own, persons who are unable to operate the heater safely and
with the guidelines of the use manual, unless constant supervision is provided.
• When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
• Indoor use only.
WARNING: Please do not attempt to open or repair the heater yourself.
Doing so could void the warranty and cause damage or personal injury.
Electricians, please ensure a copy of the Installation
Instructions are left with the end user for future reference
Page 2 of 5
Loading...