Reebok i-walk... i-run RE-11306 User Manual

21

USER MANUAL

RE-11306 • 1st Edition

RFE International Ltd
DFDS House, Maidstone Road
Kingston, Milton Keynes MK10 0AJ

Technical Support 0870 330 0024
[e-mail]

1

Contents

precautions

WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important
precautions and information before operating the treadmill. It is the responsibility of the owner to ensure that all
users of this treadmill are adequately informed of all warnings and precautions.

• Use the treadmill only as described in this manual.

• Place on a level surface, with 6 feet (2 m) of clearance behind it. Do not place the treadmill on any surface that

blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill.

• When choosing a location for the treadmill make sure that the location and position permit access to a plug.

• Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a garage or covered patio,

or near water.

• Do not operate the treadmill where aerosol products are used or where oxygen is being administered.

• Keep children under the age of 12 and pets away from the treadmill at all times.

• The treadmill should not be used by persons weighing more than 100kgs.

• Never allow more than one person on the treadmill at a time. Wear appropriate exercise clothing when using

the treadmill. Do not wear loose clothing that could become caught in the treadmill. Athletic support clothes
are recommended for both men and women. Always wear athletic shoes. Never use the treadmill with bare
feet, wearing only stockings, or in sandals.

• When connecting the power cord, plug the power cord into a grounded circuit. No other appliance should be
on the same circuit.

• Always straddle the belt and allow it to start moving before stepping onto the belt.

• Always examine your treadmill before using to ensure all parts are in working order.

• Allow the belt to fully stop before dismounting.

• Never insert any object or body parts into any opening.

• Follow the safety information in regards to plugging in your treadmill.

• Keep the power cord away from the incline wheels and do not run the power cord underneath your treadmill.

Do not operate the treadmill with a damaged or frayed power cord.

• Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be
performed by an authorized service representative, unless authorized and/or instructed by the manufacturer.
Failure to follow these instructions will void the treadmill warranty.

• Never leave the treadmill unattended while it is running.

Assembly - parts list 2

Assembly - parts diagram 3

Assembly instructions 4

Folding, unfolding and transportation 5

Computer operation 6

Maintenance 9

Workout tips 10

Limited warranty 13

2 3

assembly - parts list

NO. DESCRIPTION QUANTITY

01 Console top protector 2

02 Console top cover 1

03 Computer 1

04 Console bottom cover 1

05 Console lower protector 2

06 Console position ring 4

07 Console pin cover 1

08 Console lock pin 1

09 Stabilizer tube 1

10 Battery cover 1

11 Hand pulse sensor 2

12 Handlebar cap 2

13 Console frame 1

14 Front roller with flywheel 1

15 Rear roller 1

16 Side housing 2

17 Side cover 2

18 Roller cap 2

19 Running belt 1

20 Hinge axle 2

21 Motor hood 1

22 Drive belt 1

23 DC motor 1

24 M8 x 12mm Bolt 2

25 Motor bracket 1

26 8 x 23mm washer 2

27 Motor bumper bushing 1

28 M8 nylon nut 1

29 Spring washer 2

30 8 x 16mm washer 2

31 Rail guide screws 16

32 Rail guide 8

33 Rubber cushion bolt 8

34 Running deck 1

35 Side rail mat 2

NO. DESCRIPTION QUANTITY

36 Side rail 2

37 2mm cushion 8

38 Stabilizer foot 2

39 Stabilizer axle 1

40 Stabilizer cap 2

41 Stabilizer washer 1

42 Filter 1

43 Motor control board 1

44 Power switch 1

45 Foot 4

46 Second floor bracket 1

47 Top housing connector 3

48 Cable guide 1

49 Cable clamp 1

50 Release axle 1

51 Release knob 1

52 Lock pin 2

53 Stop bolt 2

54 Support cap 2

55 Suspension elastomer 2

56 Stabilizer grip 1

57 Wheel 2

58 Main frame 1

59 Bottom motor cover 1

60 Bottom cover 1

61 Inclination washer 2

62 Inclination foot 2

63 Inclination plate 2

64 Inclination stop 2

65 Inclination cross tube 1

66 Inclination wheel 2

67 Side rail 2

68 Roller end cap - left 1

69 Roller end cap - right 1

assembly - parts diagram

Note: Many of the parts have been pre-assembled at the factory.