Reebok I-Run RE-14301 User Manual

I-Run RE-14301 UK Edition

0208

User Manual

2

3

Contents:

1 Front Cover
2 Contents
3 Precautions
4 Parts list
5 Parts list
6 Exploded Diagrams
7 Exploded Diagrams
8 Exploded Diagrams
9 Exploded Diagrams
10 Hardware Pack / Assembly Instructions
11 Assembly Instructions
12 Assembly Instructions
13 Computer Operation
14 Computer Operation
15 Computer Operation
16 Computer Operation
17 Computer Operation
18 Computer Operation
19 Computer Operation
20 Computer Operation
21 Computer Operation
22 Heart Rate Calculation
23 Transportation
24 Maintenance
25 Incline Adjustment
26 Warranty/Customer Service
27 Contact
28 Rear Cover

PRECAUTIONS

WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following
important precautions and information before operating the treadmill.

1. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of
all warnings and precautions.

2. Use the treadmill only as described in this manual.

3. Place on a level surface, with 2m of clearance behind it. To protect the floor or carpet from damage,
place a mat under the treadmill.

4. When choosing a location for the treadmill make sure that the location and position permit access to
a plug.

5. Keep the treadmill indoors, away from moisture or dust. Do not put the treadmill in a garage or
covered patio, or near water. Failure to do this will invalidate your warranty.

6. Do not operate the treadmill where aerosol products are used or where oxygen is
being administered.

7. Keep children under the age of 12 and pets away from the treadmill at all times.

8. The treadmill should not be used by persons weighing more than 100kg.

9. Never allow more than one person on the treadmill at a time.

10. Wear appropriate exercise clothing when using the treadmill. Do not wear loose clothing that could
become caught in the treadmill. Athletic support clothes are recommended for both men and
women. Always war athletic shoes. Never use the treadmill with bare feet, wearing only stockings,
or in sandals.

11. When connecting the power cord, plug the power cord into an earthed circuit. When replacing the
fuse, an ASTA approved BS 1362 type should be fitted to the fuse carrier. A 13 amp fuse should be
used. No other appliance should be on the same circuit.

12. If you need an extension cord, use only 14 gauge cord of 1.5m or less in length.

13. Keep the power cord away from heated surfaces.

14. Never move the walking belt while the power is turned off. Do not operate the treadmill if the power
cord or plug is damaged, or if the treadmill is not working properly

15. Never start the treadmill while you are standing on the walking belt. Always hold the handrails while
using the treadmill.

16. The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden
jumps in speed.

17. The pulse sensor is not a medical device. Various factors, including the user’s movement, may affect
the accuracy of the heart rate readings. The pulse sensor is intended only as an exercise aid in
determining heart rate trends in general.

18. Never leave the treadmill unattended while it is running. Always remove the safety key when the
treadmill is not in use.

19. Do not attempt to raise, lower, or move the treadmill until it’s properly assembled. Do not change
the incline of the treadmill by placing objects under the treadmill.

20. Inspect and tighten all parts of the treadmill regularly.

21. Never drop or insert any object into any opening in/on the treadmill.

22. Only use an original power cord supplied with the machine. If a replacement is required contact
RFE international Ltd directly.

4

5

Parts List

Part no. Part name Quantity

IR-101 Console button plate 1
IR-102 Console housing -upper 1
IR-103 Console housing -lower 1
IR-104 Safety Key base 1
IR-105 Safety Key 1
IR-106 Console housing holder-upper 1
IR-107 Console housing holder-lower 1
IR-108 Console fix lower cover 1
IR-109 Computer main board 1
IR-110 Button board 1
IR-111 Safety key wire 1
IR-112 Pulse sensor wire-upper 2
IR-113 5 pin computer wire-upper 1
IR-201 Fold up grip 1
IR-202 Upright -left 1
IR-203 Upright -right 1
IR-204 Heart rate handle bar 1
IR-205 Pulse sensor set 2
IR-206 Console support tube bushing 2
IR-207 Handlebar cover right -inner 1
IR-208 Handlebar cover right -outside 1
IR-209 Handlebar cover left -inner 1
IR-210 Handlebar cover left -inner 1
IR-213 Upright lower cover-left 2
IR-214 Side cover 2
IR-215 Fold up grip connect rod 2
IR-216 Spring 2
IR-217 Upright lock pin 2
IR-218 Fold up grip connector 2
IR-219 Safety key wire -lower 1
IR-220 5 pin computer wire -lower 1
IR-301 Fold up foot cover 2
IR-302 Fold up foot 2
IR-303 Front foot base 2
IR-304 Main frame 1
IR-306 Rear transport axle cap 1
IR-307 Transportation wheel 4
IR-308 Belt cover- bottom 4
IR-309 Rear roller tube 1
IR-310 Rear roller shaft 1
IR-311 Front roller tube 1
IR-312 Front roller shaft 1
IR-401 Motor hood 1
IR-402 DC driving Motor 1
IR-403 Driving Belt 1
IR-404 Motor holder 1
IR-405 Motor holder bracket end cap -lower 2
IR-406 Motor holder bracket end cap -lower 2

IR-407 Front foot bracket 1
IR-408 Motor holder bracket locate plate 1
IR-409 Motor holder bracket base -left 1
IR-410 Motor holder bracket base -right 1
IR-411 Switch board 1
IR-412 Switch 1
IR-413 Switch board holder 1
IR-414 Electric outlet 1
IR-415 Electric outlet holder 1
IR-416 Electric protector 1
IR-417 PU cushion 1
IR-418 Motor cover -lower 1
IR-419 Transport wheel bracket 1
IR-420 Main frame foot cover 2
IR-501 Side rail 2
IR-502 Rear end cap -left 1
IR-503 Rear end cap -right 1
IR-504 Running belt 1
IR-505 Running deck 1
IR-506 Side rail guider 8
IR-601 M4x14 mm Screw 22
IR-602 3x10 mm Screw 6
IR-603 M5X14 mm screw 2
IR-604 M4X10 mm screw 8
IR-605 M5 nut 4
IR-606 M8×18 mm allen bolt 2
IR-607 4×40 mm screw 2
IR-608 M8×52 mm bolt 4
IR-609 Ø10 washer 5
IR-610 M8×130 screw 2
IR-611 M6×45 mm screw 3
IR-612 Ø10 washer 3
IR-613 M12x25 mm cap allen head bolt 2
IR-614 M6×14 screw 4
IR-615 M6 washer 4
IR-616 M4X35 screw 2
IR-617 26 washer 2
IR-618 M8 nut 5
IR-619 M8X85 bolt 1
IR-620 M8X48 bolt 1
IR-621 M10 nut 1
IR-622 M10X116 mm screw 1
IR-623 8 plate washer 10
IR-624 Ø8 spring 2
IR-625 M8×12 allen head bolt 2
IR-626 M8 bump bolt 2
IR-627 4×19 Screw 18
IR-628 M8 special bolt 1
IR-629 Ø8 washer 2
IR-630 M10×25 allen head bolt 2
IR-631 M8×30 allen head bolt 4

6

7

8

9