Red Lion ZLZ User Manual

Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MODEL ZLZ - LINEAR CABLE ENCODER
(Replaces MODEL LES)
LOW COST LINEAR SOLUTION
50 OR 500 PULSES PER INCH
STAINLESS STEEL CABLE
0 TO 50 INCHES OF CABLE MEASUREMENT
VARIOUS CABLE ASSEMBLIES AVAILABLE
Bulletin No. ZLZ-B
Drawing No. LP0734
Released 08/13
The Linear Cable Encoder can provide an accurate, yet low cost solution for Linear Measurement applications. Common applications include robotics, extrusion presses, valve positioning, textile machinery, and gate control positioning, just to name a few. The ZLZ has some unique advantages over other sensing solutions. Using a stainless steel cable, perfect parallel alignment is no longer required and with a 50 inch cable reach, it can easily be mounted away from harsh environments. The ZLZ is available in a quadrature output, allowing the sensor to operate in positioning applications.
Additional cable exit configurations, pulses per inch, and mating connectors are available on special request. Contact the factory for details.
Open Collector Output Wiring
The ZLZ sensors have open collector outputs. An open collector output brings the uncommitted collector of the encoder switching device to the external world. Because the collector element is not associated with the sensor supply voltage, the sensor output collector may be “pulled up” to external voltages (40 VDC max.) different than the encoder supply voltage . NPN open collector outputs are current sinking devices. An output signal will not be generated unless a pull-up resistor is connected from the open-collector to the positive side of an external supply. The same supply can be used for powering the unit and for the pull-up resistor.
DIMENSIONS In inches (mm)
ZLZ
SPECIFICATIONS
ELECTRICAL SPECIFICATIONS
1. INPUT VOLTAGE: 4.75 to 28 VDC
2. INPUT CURRENT: 80 mA maximum with no output load
3. INPUT RIPPLE: 100 mV peak-to-peak at 0 to 100 KHz
4. OUTPUT: NPN open collector; 250 mA max per channel; Incremental - square wave with channel A leading B during linear extension.
5. INDEX: Once per 5" cable extension or retraction
6. MAX FREQUENCY: 0 to 125 KHz
7. SYMMETRY: 180° (±18°) electrical
8. QUAD PHASING: 90° (±22.5°) electrical
9. RISE TIME: Less than 1 µsec
MECHANICAL SPECIFICATIONS
1. FULL STROKE LENGTH (FSL): 50" standard.
2. FINISH: Black powder coated aluminum
3. ACCURACY: ±0.10% FSL
4. REPEATABILITY: ±0.015% FSL
5. LINEAR RESOLUTION: Up to 500 cycles per inch (0.002" per cycle)
6. CABLE MATERIAL: 0.034" nylon coated stainless steel rope
7. CABLE TENSION: 20 oz maximum typical
8. LIFE (CYCLES): 1,000,000 predicted at zero angle cable exit
9. CONNECTOR TYPE: 6-Pin MS type connector
10. WEIGHT: 19 oz (538.64 g)
ENVIRONMENTAL SPECIFICATIONS
1. OPERATING TEMPERATURE: 0 °C to 85 °C
2. SEALING: IP65 standard
MOUNTING BRACKET
0.625
(15.875)
2.74 (69.6)
3.81 (96.8)
Ø0.20 (Ø5.08) THRU
2.25 (57.15)
4.32±0.05
(109.73±1.27)
Ø0.69
(Ø17.53)
2.25
(57.15)
6-32 x 0.312 (7.92) DEEP
4 PLS ON Ø2.00 (Ø50.8) B.C.
0.13
(3.30)
3.50 (88.9)
3.00 (76.2)
Ø0.21 (Ø5.33) THRU 4x
1.50
(38.1)
0.25
(6.35)
2.25
(57.15)
1
ZLZ ELECTRICAL CONNECTIONS
LED'S
DUAL
CHANNEL
PULSE
SHAPING
SLOTTED DISC
SHAFT
AMP.
PHOTO XISTOR'S
ZLZ WIRING SPECIFICATIONS
LE PINFUNCTION CCARPG WIRE COLOR
+VDC A RED
COMMON B BLACK
DATA A C WHITE
DATA B D GREEN
NO CONNECTION E
CABLE & CONNECTOR ASSY
(ORDER SEPARATELY)
+VDC
DATA A DATA B
COMMON
ORDERING INFORMATION
MODEL NO.
ZLZ
ACCESSORIES
CCARPG
DESCRIPTION PART NUMBER
Quadrature output, 50 PPI, Standard Housing ZLZ0050G
Quadrature output, 500 PPI, Standard Housing ZLZ0500G
Mating 6-Pin MS Connector
PART NUMBERDESCRIPTIONMODEL NO.
LEMTBR00ZLZ Mounting Bracket
CCARPG00
CCARPG0110' 6-Pin 4-Wire Cable/Connector
CCARPG2525' 6-Pin 4-Wire Cable/Connector
CCARPG5050' 6-Pin 4-Wire Cable/Connector
The Company warrants the products it manufactures against defects in materials and workmanship
LIMITED WARRANTY
for a period limited to two years from the date of shipment, provided the products have been stored, handled, installed, and used under proper conditions. The Company’s liability under this limited warranty shall extend only to the repair or replacement of a defective product, at The Company’s option. The Company disclaims all liability for any affirmation, promise or representation with respect to the products.
The customer agrees to hold Red Lion Controls harmless from, defend, and indemnify RLC against damages, claims, and expenses arising out of subsequent sales of RLC products or products containing components manufactured by RLC and based upon personal injuries, deaths, property damage, lost profits, and other matters which Buyer, its employees, or sub-contractors are or may be to any extent liable, including without limitation penalties imposed by the Consumer Product Safety Act (P.L. 92-573) and liability imposed upon any person pursuant to the Magnuson-Moss Warranty Act (P.L. 93-637), as now in effect or as amended hereafter.
No warranties expressed or implied are created with respect to The Company’s products except those expressly contained herein. The Customer acknowledges the disclaimers and limitations contained herein and relies on no other warranties or affirmations.
Red Lion Controls Headquarters 20 Willow Springs Circle York PA 17406 Tel +1 (717) 767-6511 Fax +1 (717) 764-0839
Red Lion Controls
Europe
Softwareweg 9
NL - 3821 BN Amersfoort
Tel +31 (0) 334 723 225
Fax +31 (0) 334 893 793
Red Lion Controls
India 201-B, 2nd Floor, Park Centra Opp 32 Mile Stone, Sector-30
Gurgaon-122002 Haryana, India
Tel +91 984 487 0503
Red Lion Controls
China
Unit 302, XinAn Plaza
Building 13, No.99 Tianzhou Road
ShangHai, P.R. China 200223
Tel +86 21 6113 3688
Fax +86 21 6113 3683