RealTrace Mini Reader RT10M User Manual

1

“Mini Reader RT10M”

The “Mini Reader” is the smallest RFID reader known today. In spite of its very small size the reading range is equal or
even greater than other bigger models and more expensive.
This product is mainly used for animal tag ID microhip. It can read any work based on ISO 11784 / 85 protocol animals
tags especially the FDX B.

Technical parameter

Operation

Power on

Push the button, the “Mini Reader” power on. The LCD display shows :

Power off

The “Mini Reader” will auto power off in the absence of any action after 15 seconds except if it is connected to a PC
USB port directly or by a cable line.

Set language

When the “Mini Reader” is power down, push the button brevemente until to hear a “beep”, in order to enter to setting
“LANGUAGE” or “MEMORY” mode. Stop to push the button when the display shows “LANGUAGE” The different

languages will scroll on the display. Each language will remains 2 seconds. When the language you want to setting, just
push the button. Then the reader will use the setting when next power on.

Remarks: when the battery LI-Ion is low powered, the key reader may not read any tag or can read in a very short
distance. If the temperature is lower than 10° the reading range will be decreasing

Frequency

134.2KHz

Battery

Li-ion，3.7VDC,170mAH

Charging current

5VDC on USB connector

Charging indication

Red LED in charging.
Green LED when complete.

Read Range

≥ 60/70mm

Read indication

Beep、Blue LED、LCD indication

Dimensions

109×34×14mm

Operating temperature: (while battery under charge)

+5° /40°

Memory

128 ID numbers

Mini Reader

2

Scanning for an animal tag

Push the button. Scan slowly the area where a microchip is expected to be found while keeping the reader for a few
centimeter's distance from the animal's skin. The reader will be scanning for about 20 seconds. The blue light flash, the
display is black.
If a tag is detected the reader will “beep” and the identification number is displayed as follow:

XXX = country ISO code or manufacturer code (3 figures)
xxxxxxxxxx = individual identification number, (12 figures ).
If no microchip has been found after 20 seconds searching, the following message will be displayed on the screen. The LCD
screen will stop displaying the message after about 15 seconds.

If this situation arises, try finding the microchip again. To do so you must re-activate the reader by pressing the button.
Scan the possible microchip implantation area with as large and sweeping movement as possible. If necessary, repeat the
operation after having re-activated the reader again.

Charging the battery

Directly connected to PC USB the Mini Reader will be charging automatically .
Red light when in charging, green light when charge is complete.

Remarks: when the battery LI-Ion is low powered, the key reader may not read any tag or can read in a very short
distance. If the temperature is lower than 10° the reading range will be decreasing.

XXX xxxxxxxxxxxx

No tag found!

3

Reading range

hasta 7,5cm

Glasstag FDX B 2 x 12mm

Bobina