Realistic RadioShack Comp-100 Programming sheet

COMP-100 5-Band FM Scanning Monitor Receiver
(200-0110) Operation

Programming

1. Select the channel you want to enter a program frequency by pressing
the MANUAL button as many times as required to move the light on the
channel indicators to that desired channel.

2. Slide the Program Door open and press in the PROGRAM button. If the
Program Indicator lights up, the unit is ready to receive a new
program.

3. Find the code from the Code Table to match the frequency you want.
The numbers tell you which Digit Swittches should be "out" and * marks
show which digit switches remain "in".

4. After you have set the code into all 16 Digit Switches, press the
ENTER button. The Code Indicators are lighted to reflect the new
program code for the frequency entered.

5. Press the PROGRAM button again to release it (button out). The
program light goes out, the code indicator LEDs go out and the only
light "on" is for the selected channel.

6. Press all of the Digit Switches in (buttons in).

7. To enter another program, select a channel and the frequency desired
and repeat Steps 1 through 5.

8. After programming, close the program door, and you are ready to
receive signals.