RCBS Universal Hand Priming Tool User Manual

PRECISIONEERED RELOADING EQUIPMENT

We think that we make the very best reloading equipment in the world.

If you agree, please tell your friends.

If you disagree, tell us - we want to do something about it!

Customer Service

1-800-533-5000 (US or Canada) or 530-533-5191

Hours: Monday - Thursday, 6:30am - 3:00pm Pacific Time

(hours may vary)

e-mail: [e-mail]

RCBS, 605 Oro Dam Blvd. East, Oroville, CA 95965

OUTERS - RAMLINE - ORBEX - FEDERAL

or visit our website at www.rcbs.com

CCI - SPEER - RCBS

7200539/0509

_____________________________

UNIVERSAL
HAND PRIMING
TOOL

PRODUCT INSTRUCTIONS

SAFETY

Reloading is an enjoyable and rewarding hobby that is easily conducted with
safety. But carelessness or negligence can make reloading hazardous. This
product has been designed from the beginning with the user’s safety in mind.

As with any reloading operation, some safety rules must be followed. By
observing these few rules, the chance of hazardous occurrence causing damage
or injury becomes extremely remote.

GENERAL

• Use the equipment as the manufacturer recommends. Study the instructions

carefully and become thoroughly familiar with the operation of the product.
Don’t take short cuts.

• Observe “good housekeeping” in the work area. Keep tools and

components neat, clean and orderly. Promptly clean up any powder spills.

• Always wear adequate eye protection.

• If any unusual resistance is encountered when moving the operating handle,

STOP IMMEDIATELY and investigate the cause. To proceed against
unusual resistance may damage equipment and/or cause serious injury!

LOADING DATA

• Use only laboratory tested data. We highly recommend the use of the

SPEER Reloading Manual.

• OBSERVE ALL WARNINGS ABOUT THE USE OF MAXIMUM

LISTED LOADS.

PRIMER HANDLING

• WARNING: Primers are designed to explode and will do so when subjected

to heat or percussion.

• Do not decap live primers!

• Never attempt to seat or reseat a primer in a loaded cartridge.

• Store primers and powder beyond the reach of children and away from heat,

dampness, open flames and electrical equipment.

• DO NOT use any primer unless its identity is positively known. Discard all

mixed primers and those of uncertain or unknown identity.

• After a reloading session ends, return the remaining primers back into its

original factory container. This will preserve the identity and shelf life of
the primers.

• DO NOT SMOKE while handling powder or primers.