RCA RB3510 Owner’s Manual

PROSCAN®

, "E&Ti"_RED OCTO

Assembly Instructions for

Stand Models RB2710 / RB3110 / RB3510

The contemporary design of this stand and its
companion TV models will complement the furniture

iLnany room. The stand gives you beautiful, organized
,storage for your video and audio equipment.

Attaching and Adjusting Glass Doors

1. Hold the glass door up next to the stand to determine

where the top hinge will be attached. You will repeat
steps 1 through 5 when attaching the opposite glass door.

AU_h hinge to fop _de

of door wiffi _rew _L

toward Inside. a_

Inside _ __

12. Partially thread one screw into each of the
door hinges. Make sure the screw is

inserted through the holes in both the

hinge and the inside bracket. Then

attach the top hinge to the upper left

comer of the glass door. Gently tighten
the screw until the hinge is tight against
the glass. Do not attach the bottom hinge

to the door yet.

Outside

4. Insert the top hinge of the glass door into the top bushing.
(If the bushing is resting on top of the hinge, insert the

hinge and bushing into the top hole.) Insert the bottom
hinge into bottom hinge bushing and hold it in place while
sliding bottom of glass door into hinge. Then gently
tighten bottom hinge against the glass door.

to glass) Into top hole.

11_en put botfom
hinge in hole and slide
gla_ door Into the

bottom hinge. Gently

Ughten screw.

The glass door should open and close easily without
rubbing on the stand. You can adjust the position of the

glass door if necessary by slightly loosening the hinge

=

screws, moving the door, and then retightening the screws.

3. Place one hinge bushing into each

of the two hinge holes in the stand.
If the fit is snug, tap them in with

a hammer.

If the bushing does not fit
securely in the top hole (falls

out), place it ot_the door over
the pin on the top hinge.

If top bushing wM not stay In

top hole, place it on fop hinge.

5. Attach push plate to top edge of door where it contacts the

magnetic catch already attached to the stand. First adhere
the foam pad over the top of the door, and then slide push
plate over the pad.

Attach foam pad and push

where door con_,_

magnetic

3