RCA LED47A55RS, LED42A55RS Owner’s Manual

Model Number°

Part No.:ES-J100256

Changing Entertainment. Again.

www.rca.com

FCC Statement

NOTE: The manufacturer is not responsible for any radio or "IV interference caused by unauthorized

modifications to this equipment. Such modifications could void the user's authority.

NOTE: This equipment has been tested and found to comply with the limits for a class B digital

Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio Communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and the receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Safeguards

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude

to constitute a risk of electric to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing)

instructions in the literature

accompanying the appliance.

TO REDUCE THE RISK OF AN ELECTRIC

SHOCK, DO NOT REMOVE THE COVER (OR

BACK). THERE ARE NO USER SERVICEABLE

PARTS INSIDE. FOR ANY REQUIRED

SERVICING, PLEASE CONTACT QUALIFIED

Important safety instructions

CAUTION: USE OF ANY CONTROLS, ADJUSTMENTS, OR PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY

RESULT IN HAZARDOUS RADIATION EXPOSURE. CAUTION:

These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do

not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer to service manual for servicing instructions.

CAUTION

SERVICE PERSONNEL.

important safety instructions

1. Read these instructions

2. Keep these instructions

3. Heed all warnings

4. Follow all instructions

5. Do not use this apparatus near water

6. Clean only with dry cloth

7. Do not block any ventilation openings

8. Do not install near any heat sources

9. Do not defeat the safety purpose of the polarized or grounding-type plug

10. Protect the power cord from being damaged particularly at plugs, convenience receptacles, and at points in which they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

Safeguards

14.

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the

power-supply cord or plug is damaged, when liquid has been spilled or when objects have fallen into the apparatus, or when

the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.

POWER SOURCE: This TV should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For TVs intended to operate from battery power, or other sources, refer to the operating

instructions.

16.

POWER CORD PROTECTION: Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying

particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

17.

OUTDOOR ANTENNA GROUNDING : If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is

grounded to provide some protection against FIGURE A voltage surges and built-up static charges,

Section 810 of the National Electrical Code, NATIONALELECTRICALCODE ANSI/NFPA NO.70, provides information

with respect to proper grounding of the mast and supporting structure, grounding

of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to

grounding electrodes, and requirements for the grounding electrode. (Fig.A) $2898A "<_ POWERSERVICEGROUNDING

18.

LIGHTNING: For added protection for this TV receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the TV due to lightning and power line surges.

19.

POWER LINES: An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care

should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

EXAMPLE OFANTENNA GROUNDINGAS PEF

CLAMP\/_, c

GROUNDJ'

__ GROUND CLAMPS

ANTENNA LEAD IN WIRE

ELECTRODESYSTEM

III

Safeguards

20. OVERLOADING: Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

21. OUTDOOR USE: Do not install this TV outdoor. If the TV is exposed to rain, it may result in a fire or an electric shock. If the TV is exposed to direct sunlight, the TV may

heat up and cause damage to the TV.

22. VEHICLE: Do not install the TV in a vehicle. Bumping of the vehicle may cause the TV to fall down and cause injury.

23. SHIP AND VESSEL: Do not install this TV in a ship or vessel. If the TV is exposed to seawater, it may cause a fire or damage the TV.

24. OBJECT AND LIQUID ENTRY: Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that could

result in fire or electric shock. Never spill liquid of any kind into the TV.

25. SERVICING: Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to

qualified service personnel.

26. REPLACEMENT PARTS: When replacement parts are required, be sure that the service technician uses replacement parts with the same characteristics as the

original parts specified by the manufacturer. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.

27. SAFETY CHECK: Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in

proper operating condition.

28. The apparatus should not be exposed to any dripping or splashing, and no objects filled with liquids (such as a vase) should be placed on the apparatus.

29. WARNING: Plug the power cord into a power outlet where access to the power cord connector is readily accessible, in case if the power needs to be immediately

disconnected.

30. ATTENTION: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

a). Disposal of packaging:The packaging of this product is intended to be recycled. Apply

to the local authorities for correct disposal.

b). Disposal of batteries: The batteries supplied do not contain the heavy metals mercury

and cadmium. Please check on how to dispose exhausted batteries according to local regulations.

c). Note Specifications and information are subject to change without notice. Ifyou need

further assistance, please call the customer support service in your country.

31 .POWER=CORD INSERT CHECK:When connecting the power cord to the connector of the

TV, make sure the power cord is fully inserted in the place. Bad contact may cause high

temperature of the connector and the risk of fire or other damages.

Safety Strap

To secure TV to stand or Wall, use hardware listed below (Not Supplied)

1. Attach the wall anchor on the stand.

2. Tie the ropes or chains with TV pedestal screws. Ropes or chains should be secure tightly.

3. Fasten the anchor bolts into top wall-mount holes.

4. Attach the wall anchors on the wall strong enough to support the weight of the TV. (Attach to the

Wall Stud).

5. Make sure to connect anchor bolts to wall anchors.

• Anchor bolt - M6 x 10mm (42"and 47") or M6x 16mm(55")

:::;222

6. Check that all connections are properly secured. Periodically check for any sign of fatigue or failure. If you have any doubt about the security of your connections, contact a professional

installer.

Table of Contents

1.Important to user ...................................................................................... i

2.Important safety precautions .................................................................... ii

Safeguards ....................................................................................... ii

Safety Strap ....................................................................................... V

3.Table of Contents ..................................................................................... 6

4.Setting Up ................................................................................................. 7

Installing the Stand ...................................................................... 7

Wall mount specifications ...................................................................... 7

Wall mount ......................................................................................... 8

TV Front ........................................................................................... 10

TV Rear ............................................................................................ 11

Connect to other devices ................................................................. 12

5.Using the Remote Control ....................................................................... 15

Installing the remote control batteries ............................................... 15

Learning about the Remote Control Panel ....................................... 16

Quick starts ...................................................................................... 17

6.Changing the TV Settings ....................................................................... 19

Using the TV Menu .......................................................................... 19

Using the Video Menu ..................................................................... 20

Using the Audio Menu ..................................................................... 22

Using the Setup menu ..................................................................... 23

Using the Parental menu ................................................................. 26

7.Appendix ................................................................................................. 29

Trouble shooting .............................................................................. 29

Specifications ................................................................................... 30

Installing the Stand/Wall mount specifications

Installing the Stand

F .......................................................................................

1. Lay a cloth or another soft material on a fiat surface to avoid damage to the LCD screen.

2. Put the TV back upward and the LCD screen downward and keep it flat on the table-board.

3. Take out the stand and insert the stand into the installing slot in the lower part of the TV, then put the stand to relevant position of the TV set until all the holes match each other completely.

4. Fasten the stand and the TV set together with the 4 screws provided. Erect the TV set, and put it on the proper position for watching.

Note:

The above figures are for reference only, please refer to the actual units to determine the appearances.

Every hole of the stand must be fastened with screws!

Wall mount specifications

Install your wall mount on a solid wall perpendicular to the floor. When attaching to other building materials, please contact your nearest dealer. If installed on a ceiling or slanted wall, it may fall and

result in severe personal injury.

- Dimensions for wall mount kits and wall-mount screws pattern please refer specifications table.

- Do not use screws longer than the standard dimension, as they may cause damage to the inside of the TV set.

- For wall mounts that do not comply with the VESA standard screw specifications, the length of the screws may differ depending on their specifications.

- Do not use screws that do not comply with the VESA standard screw specifications.

- Do not fasten the screws too strongly, this may damage the product or cause the product to fall,

leading to personal injury. o Proscan is not liable for product damage or personal injury when a non-VESA or non-specified wall

mount is used or the consumer fails to follow the product installation instructions.

Do not exceed 15 degrees tilt when mounting this TV.

Wall mount Wail-mounting Bracket Instai|ation

LED42A55RS LED47A55RS

Unit Dimension(Unit:mm) 200 x 200 200 x 200

Screw Diameter M6 M6

Screw Length(Unit:mm) 25 25

NOTE: Wall mount bracket is not included with TV and mounting of wall mount bracket to wall

may vary depending on brand and size of bracket. Customer should consult bracket mounting

instruc ions that came with wall mount for specific information on how to mount bracket to wall.

Removing TV Stand

1. Cover the surface of the table with soft cloth to avoid damage to LCD panel.

2. Lay the TV on a plane table which could bear a weight enough.

3. Remove the 4 bolts fixing the stand and remove the stand from TV.

Before reading the installing instruction, please notice:

The wall mount is not contained in the accessories sold with television. We only provide the installing specifications but not the wall mount itself. Ifyou need the mount, please consult with the local dealer

for the assorted fitting parts.

B. We strongly suggest to set the wall mount with equipments of specification we ordered. If not,

inappropriate installing may cause damage to both the device and yourself.

Wall mount

When Installing the "iV Against a Wail or Enclosed Area

Make sure that your TV has adequate air circulation. Allow enough space around

the TV as shown below. Avoid operating the TV at temperatures below Inadequate air 45 ° F (5°C)

Instand with stand 12_nehes

........ ?

4 inches

6ore

2.375 inches

Leave at least this much space ar the

Install on the wall 12_nches

4 inches

lOcm _

Never install the TV set as follows:

Air circulation is blocked.

wall

set,

4 inches

Leave at least this much space around the set.

Inadequate air circulation can lead to overheating of the TV and may cause damage to your TV or cause a

fire.

+ 22 hidden pages