Ramsey 295946, 295947 User Manual

INSTALLATION INSTRUCTIONS FOR SIERRA

GRILLE GUARD KIT # 295946 AND

WRAPAROUND KIT #295947

ON 1999-2007 FORD F250-550

SUPERDUTY AND 2002-2005 EXCURSION

Notice

Ramsey kits are designed for use with Ramsey Winches only.

Use or sale of kits for other winches or applications voids warranty.

Warning

Ramsey offers mounting kits and winches for various vehicles. In crash tests on a limited number of automotive
manufacturer’s vehicles, winches/mounting kits, which have been properly mounted, have not interfered with air bag
operation.

The user/customer, or their installer, must verify that the mounting kit does not interfere with the factory air bag sen­sors, which must not be relocated or modified in any way.

The user/customer should follow the vehicle manufacturer’s recommendations and those of a qualified mechanic to
determine if the winching/mounting kit might interfere with the air bag operation. The user/customer should then
determine the suitability of a winch/mounting kit on a particular vehicle.

PLEASE BE ADVISED THAT THE VEHICLE’S AIR BAG SYSTEM MAY NOT OPERATE PROPERLY IF THE
WINCH/MOUNTING KIT IS NOT MOUNTED IN COMPLIANCE WITH THE VEHICLE MANUFACTURER’S RECOMMEN­DATIONS.

DO NOT ATTACH TOW HOOK TO ANY PART OF MOUNTING KIT UNLESS INSTRUCTED TO DO SO.

DO NOT SUBSTITUTE ATTACHING HARDWARE ITEMS (BOLTS, NUTS, OR WASHERS).

READ AND UNDERSTAND WINCH OWNER’S MANUAL BEFORE INSTALLATION AND OPERATION OF THE WINCH.
SEE WARNINGS AND CAUTIONS IN WINCH OWNER’S MANUAL.

IMPORTANT NOTES!

1. RIGHT AND LEFT HAND DIRECTIONS AS IF SEATED BEHIND STEERING WHEEL.

2. ALL FASTENING HARDWARE MUST BE LOOSELY ASSEMBLED UNTIL DIRECTED TO TIGHTEN.

RAMSEY WINCH COMPANY

P.O. BOX 581510

TULSA, OKLAHOMA 74158

PHONE: [phone] • FAX: [phone]

http://www.ramsey.com

913398-0307-B

1. Remove vehicle bumper in order to access
tow hooks and frame.

2. Remove tow hooks by removing (3) 12mm factory bolts.

3. Remove the three nuts on the underside of the blocker bar as
shown at lower right. Remove blocker bar.

On some models, to remove the blocker bar, remove the four
bolts that hold the blocker bar to the bracket as shown
below.

2

FOR 1999-2004 MODELS:

4. Fasten upper support brackets (item #5 & #6) to vehi­cle bumper bracket as shown at right using factory hard­ware.

FOR 2005 MODELS:

4a. Take (1) 1/2” bolt with rod (item #17) and place (1) 1/2”

flat washer (item #18) on bolt and hold in place using
(1) plastic gasket (item #23), threaded onto bolt.

The following views are looking up from underside of
vehicle with orientation to front of vehicle as indicated.
Driver side shown.

4b. Locate slotted holes in bottom of frame and on outside of

frame rail as shown at right.

3