Rae MultiRAE Plus PGM-50/4, MultiRAE Plus PGM-50/5P, MultiRAE Plus PGM-50/4P User Manual
008-4022-000, Revision B, November 2003
Monitor Only
(not shown)*
Shipping case
008-3040-000
Alkaline battery adapter
®
Windows
95, 98, 2000,
with a MultiRAE Plus monitor that is datalog-enabled.
Attention! For European Applications
A. 0575 II 2G
5,393,979 , 5,561,344 ,
Read Before Operating
with the manufacturer’s instructions.
!
!
!
Warnings
Any rapid up-scale reading followed by a declining or erratic
!
!
!
!
!!!
Avertissements
journalière.
!
!
!
!
!
!
!
Table of Contents
Alarm Signals • 10
Accessories • 15
vi
Adjust Lamp Failure Threshold • 27
1
M
. The monitor will beep once and go through a
(customizable using ProRAE Suite software)
(As the MultiRAE Plus checks each sensor, it displays
Alarm Limits
(for High, Low, STEL, TWA)
(The last calibration date must be within the last 30
Alarm Mode
after the warm-up is complete, press and hold
M
for 5
Advanced
!
MO DE
MO DE
3
to advance
Advanced
(toxic gas) – ppm
VOC
(volatile organic compound) – ppm
(lower explosive limit) – percentage
(oxygen) - percentage
“****” will appear
MO DE
A fully charged battery
will be 4.8 V or greater. When
- the runtime is how long the
turns manual
Correction factor may only
VOC Gas -
Correction factor may only
- capable of printing
This feature
5
While all instruments are calibrated prior to leaving the factory,
When should you calibrate the monitor?
!
TOX1
VOC TOX2
LEL
OXY
0000
M
and [N/-] for 5 seconds.
will be prompted for a password. Use [Y/+] to
to move on to
to submit the password.
Y/+
N/-
MO DE
MO DE
MO DE
Attach the filter to the MultiRAE Plus during
Y/+
TOX1
VOC TOX2
LEL
OXY
Y/+
TOX1
VOC TOX2
LEL
OXY
7
Apply the RAE Systems 4-gas span gas
Y/+
Y/+
TOX1
VOC TOX2
LEL
OXY
TOX1
VOC TOX2
LEL
OXY
OXY
TOX1
VOC TOX2
LEL
OXY
If calibration is accidentally started and gas has run out or has
repeatedly. Calibration will stop and revert
MO DE
A time stamp is created and stored each time a sensor calibration is
twice to exit calibration mode and return to the main display.
Residual gas may linger on the sensors for up to 60 seconds.
MO DE
to move from sensor to sensor.
Apply span gas mixture and start gas flow.
Y/+
Y/+
MO DE
TOX1
VOC TOX2
LEL
OXY
TOX1
VOC TOX2
LEL
OXY
TOX1
VOC TOX2
LEL
OXY
Some sensors (Cl
PH
Y/+
Loading...