Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
Thank you for purchasing your Mini RC Train
from RadioShack.
60-1256
Silver Line RC Train
Controller
Curve tracks (8)
Straight Tracks (5)
Divert Track Switch (1)
Connecters (18)
Signal lights (2)
Charging Garage (1)
End Track pole - snaps into Straight Track (1)
Sound and light station (1)
Locomotive (1)
Passenger Car middle (1)
Passenger Car end (1)
Note: Actual product may vary from the images found in this
document.
1. Remove the battery compartment cover and
replace when fi nished.
2. Install one 9V alkaline battery as indicated by
the polarity symbols (+ and -) marked inside.
3. Repeat these steps to install batteries in the
Charging Station (three AA alkaline batteries)
and Train Station (three AA alkaline batteries).
Charge the locomotive before using
it the fi rst time.
Controller
Locomotive
Passenger cars
Light and Sound
Train Station
Signal Light
Recharging
Garage
End Track
Train Station
On/Off
Switch
On/Off
Switch
Locomotive
On/Off Switch
Forward
Switch 2
(for backing
onto endtrack)
On/Off
Switch 1
(for driving
into charging
station)
Reverse
Stop
Charging Garage
Charging Your Train
When your train slows down it needs to
be recharged.
Signal Light
1. Turn and hold the Switch
on the Controller to Switch 1
2. The divert track switch at the
intersection lets the train
drive into the charger
4. The red indicator
lights up to show the
engine is charging.
3. To charge the engine,
press down the Charging
Button when the engine
is in the Charging Garage.
5. The green light indicates
charging is complete.
Track Connector
6. Press the release button
to release the engine.
Setting Up
1. Assemble the train track as shown
above
2. Turn on each piece in the order below.
3. Set the locomotive
on the track and
connect the cars.
4. Use the forward and
reverse switches on
the controller to move
the train.
NOTE
©2004. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
60-1256
07A04
Printed in China
This product is warranted by RadioShack against manufacturing defects in material and
workmanship under normal use for ninety days (90) from the date of purchase from
RadioShack company-owned stores and authorized RadioShack franchisees and dealers.
For complete warranty details and exclusions, check with your local RadioShack store.
RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/04
The EPA certifi ed RBRC(r) Battery Recycling Seal on the
nickel-cadmium (Ni-Cd) battery indicates RadioShack is
voluntarily participating in an industry program to collect and
recycle these batteries at the end of their useful life, when
taken out of service in the United States or Canada. The
RBRC program provides a convenient alternative to placing
used Ni-Cd batteries into the trash or the municipal waste
stream, which may be illegal in your
area. Please call 1-800-THE-SHACK (1800-843-7422) for information on Ni-Cd
battery recycling and disposal bans/
restrictions in your area. RadioShack’s
involvement in this program is part of the
company’s commitment to preserving
our environment and conserving our natural resources.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult your local RadioShack store or an experienced
radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires
that you stop using your phone. Changes or modifi cations
not expressly approved by RadioShack may cause
interference and void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
Signal Light
• Keep your Silver Line RC Train dry; if it gets wet,
wipe it dry immediately.
• Use and store the Silver Line RC Train only in normal
temperature environments.
• Handle your Silver Line RC Train carefully; do not
drop it.
• Keep your Silver Line RC Train away from dust and
dirt, and wipe it with a damp cloth occasionally to
keep it looking new.
• If your Silver Line RC Train is not performing as it
should, take it to your local RadioShack store for
assistance. To locate your nearest RadioShack, use
the store locator feature on RadioShack’s website
(www.radioshack.com), or call 1-800-The Shack
(843-7422) and follow the menu options. Modifying
or tampering with your Silver Line RC Trains internal
componets cause a malfunction and might invalidate
its warranty.
Switch 2
When you want to park a car on the
End Track, do the following.
1. Allow the train to pass
the divert track switch at
the end of the
track completely.
End Track
2. Turn and hold the switch on the
controller to Switch 2. This diverts
the straight track to allow the train
to back onto the end track.
3. Turn the Forward and Reverse switch on
the controller to Reverse to drive the train
back onto the end track. Disconnect the last
car by hand.
1. When you choose to stop the train
at the Sound and Light Station the
red signal light will turn on.
2. An announcement will then
be heard.
3. After the announcement is over the signal
light will turn green. Drive the train from the
station. A horn sound will be heard when
the train is running on the track.
“Now Arriving on Track
Number One Train Number
545- SILVERLINE! “
(train bell rings then the sound of the
train coming into the station is heard)
“ALL ABOARD! SILVERLINE
NUMBER 545 ALL ABOARD!”
Reverse this process to pick
up the last car again.
NOTE
If you choose not to stop at
the Sound and Light Station no
announcement will be heard.
NOTE
• Batteries to be installed by adults only.
• Use only fresh batteries of the required size
and recommended type.
• Do not use batteries of different types
capacities, or chemistry.
• If you do not plan to use your RC Train
for several days, remove the batteries.
Batteries can leak chemicals that can
damage electronic parts.
• Any batteries purchased for use in this toy
may pose a hazard to children. Please check
safety notice supplied with batteries before
use.
• Dispose of old batteries promptly and
properly. Do not burn or bury them.
Reverse
Loading...