Heavy Duty 7-Day Digital Timer
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack Heavy Duty 7-Day Digital
Timer gives you an easy way to p rogram a
lamp, TV, stereo, or other appliance to operate automatically in a set or random pattern.
Its features include:
Up to 98 ON/OFF Weekly Settings
— let
you program one appliance to turn on and off
up to 14 times a day, every day of the week.
Random Switch Setting
— turns the appliance on for five minutes to an hour (in a random pattern) four to 12 times a day to avoid
a predictable “timer-controlled” look.
Manual Override
— lets you turn the auto-
matic timer on and off when you desire.
Various Length Settings
— let you program
the timer to operate only on a particular day
of the week, every day, only weekdays, only
weekends, or every day but Sunday.
Highly Accurate
— the timer is accurate to
the minute, providing you with precise timing
in any setting.
Your Heavy Duty 7-Day Digital Timer is listed
to UL standards and meets all applicable
FCC requirements.
WARNING:
shock hazard, do not expose this product to rain
or moisture.
To reduce the risk of fire or
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION:
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
!
Warning:
TO REDUCE THE RISK OF
This symbol is intended to alert
you to the presence of uninsulated dangerous voltage within
the product’s enclosure that might
be of sufficient magnitude to constitute a risk of electric shock. Do
not open the product’s case.
This symbol is intended to inform
you that important operating and
maintenance instructions are
included in the literature accompanying this product.
Do not use the timer to turn off
!
power for maintenance (repairs, removing
broken bulbs, etc.). Always turn power off at
the service panel by removing a fuse or circuit breaker before doing any circuit repairs.
INSTALLING THE BACKUP
BATTERIES
Your timer requires two L1154 button-cell
batteries (supplied) for power. For the best
performance and longest life, we recommend RadioShack alkaline batteries.
2001 RadioShack Corporation. All Rights Reserved.
©
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
The batteries retain the program during power
outages. After removing the batteries, you
have 15 seconds to insert new batteries without losing any programs.
Warning:
Keep button-cell batteries away
from children. Swallowing a button-cell battery
can be fatal.
Cautions:
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries, or different types of batteries.
Follow these steps to install batteries.
1. Unplug the timer.
2. Use a small, flat screwdriver to remove
the battery carrier.
3. Place both batteries in the compartment
as indicated by the polarity symbols (+
and –) marked inside.
4. Align the notch on the battery carrier with
the indention in the holder, then slide the
carrier into place.
A QUICK LOOK AT THE
DISPLAY
Daylight Savings
Symbol — appears
when it is Daylight
Savings time. Hold
down DS to turn the
symbol off.
AM/PM
Setting —
indicates
the time
of day.
Program
Symbol —
the number
to the right
of this indicates which
program is
running.
Day — shows the
current day of the
week.
Countdown Timer
Clock — appears
when the timer is
in countdown
mode.
On/Off Symbol —
indicates the timer is on or an on
time is being programmed. A light
bulb with an X on
it indicates the
timer is off or an
off time is being
programmed.
Mode Indicator —
shows which
mode the timer is
currently in.
SETTING THE CLOCK
Before you program the clock, the timer must
be set to On, Auto, or Off. The appliance can
be on or off.
5. Plug the timer into an outlet.
When the display dims or is weak or unreadable when the timer is unplugged from an outlet, replace the batteries. When you replace
the batteries, follow Steps 1–5. If the display
goes blank, use a straightened paper clip to
press
Warning:
.
RESET
Dispose of old batteries promptly
and properly. Do not burn or bury them.
Caution:
If you do not plan to use the timer for
an extended period of time, remove the batteries. Batteries can leak chemicals that can
destroy electronic parts.
If it is Daylight Savings time, hold down
Note:
for a couple of seconds until the Daylight
DS
Savings symbol appears. If it is not Daylight
Savings time and the Daylight Savings symbol
is on, hold down
for a couple of seconds
DS
until the symbol turns off. The Daylight Savings symbol (
) appears or disappears and
6666
the time switches one hour in the appropriate
direction.
1. Push and hold
TIME SET
. The blinking
colon stops blinking and appears steadily.
2. While holding
Repeatedly press
TIME SET
:
to change the day
DAY
of week.
Repeatedly press
to change the
HOUR
hour and AM/PM.
2