Radio Shack Handsfree Speakerphone Kit Owner's Manual
Handsfree Speakerphone Kit for Sanyo
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack Handsfree Speakerphone Kit is easy to use.
It turns your cellular or PCS phone into a speakerphone in your
car or truck. Just plug it into any standard (negative ground)
12-volt power source, such as a cigarette-lighter socket, connect it to your phone, plug in the microphone, and it is ready to
use. It even automatically recharges the phone’s battery.
Warning: Always wear your seat belt. Never place a phone
where it could damage or interfere with the operation of any
passive safety device (airbags or seat belts).
Notes:
•
For safety and the best performance, hold your phone
upright with a dash-mounted phone holder, available at
your local RadioShack store
• To avoid lockup of the speakerphone system, always disconnect the speakerphone kit from power before starting
your vehicle.
.
© 2001 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com
are trademarks used
by RadioShack Corporation.
A QUICK LOOK AT YOUR
SPEAKERPHONE KIT
Plug
D
N
A
H
Speaker
P
S
E
E
R
F
S
Power & Mode
Indicator
E
N
O
H
P
R
E
K
A
E
Mode-Switching
Finger Groove
Phone
Connector
Volume
MIC
Cord
PREPARATION
1. Insert the speakerphone’s plug into your vehicle’s 12-volt
power source or cigarette-lighter socket. The green
POWER indicator lights. Turn the speaker grill toward you
to allow at least 2 inches of clearance so you can use the
mode switch on the back.
Notes:
• You might have to turn the ignition key to Accessory or
ON to power the cigarette-lighter socket.
• If your vehicle’s cigarette-lighter socket is difficult to
reach, outlet adapters are available at your local
RadioShack store.
2
2. Plug the phone connector, located on the end of the coiled
cord, into the slot on the base of the phone. TOP should
face the same direction as the keypad. The connector will
only fit one way; do not force it.
3. Plug the microphone into the MIC jack located on the side
of the speakerphone.
Note: Replacement microphones (RSU 12294229) are
available through your local RadioShack store.
4. You can attach the microphone to either your car’s visor
or your clothing.
To use the supplied visor clip to attach the microphone to
the visor, tuck the wire into the space between the windshield glass and trim, or under the trim, whichever is easier. Run the wire down to the dash and around the dash
edge, being careful not to put the wire where it can be
pinched by the door. Plug the microphone’s plug into the
side of the speakerphone. Make sure the microphone is
pointed toward you.
To use the small supplied lapel clip to attach the microphone to your clothing, attach the clip about 6 inches
below your chin. Leave a comfortable length of cord
between the microphone and the speaker. Wrap up the
excess cord so it does not interfere with vehicle operation.
Note: To avoid feedback, position the microphone so it is
not directly in line with the speaker. You might need to
turn the speaker slightly.
3
Loading...