Radio Shack 49-118 User Manual

LED
Alarm
Adhesive Strip (3)
Keys
Choosing a Location
1. Align the triangle on the magnet with the engraved line on the left or right side of the alarm.
2. Place the magnet edge no more than
5
/16 - inch (8 mm) from the alarm.
3. Mount the alarm to a door or window and the magnet to the door or window frame using the supplied adhesive strips or screws.
DOOR/WINDOW ALARM
Using Your Alarm
Instant Activation
1. Slide INSTANT/DELAY switch to INSTANT.
2. Insert key and rotate to ON.
3. If you move the magnet away from the alarm, it sounds for about 90 seconds. Then, the alarm turns off and the LED
Magnet
Anchor (4)
Screw (4)
Mounting Your Alarm Using Screws
1. Use the supplied drilling template to mark the mounting screw location.
2. Drill two 1/16 - inch (2 mm) holes.
3. Insert the top screw, leaving about 1/8 - inch (3 mm) to engage the keyhole on the alarm.
4. Install the alarm over the top screw.
5. Slide off the battery cover.
6. Insert the lower screw through the hole inside the battery compartment.
Battery
Cover
flashes green. Turn the key to OFF if you want to silence the alarm immediately.
Delay Activation
1. Slide INSTANT/DELAY switch to DELAY.
2. Insert key and rotate to ON. The LED lights green and you have 15 seconds to
leave and close the door. After 15 seconds, the alarm arms and the LED turns off.
Deactivation
1. When you return home and open the door, the LED lights red and you have 10 - 15 seconds to turn off the alarm.
2. Turn the key to OFF to disarm. If you do not disarm it, the alarm sounds for 90 seconds.
3. If the alarm was triggered while you were away, the LED alternately flashes green and red after the alarm has sounded for 90 seconds.
Setting Up Your Alarm
Drilling
Template
Wireless · Key-Lock
Mounting the Magnet
1. Use a small, flat bladed screwdriver to remove the mounting plate from the magnet.
2. Use the supplied screws or adhesive strips to secure the mounting plate to the selected surface. Do not use both strip and screws.
3. Connect magnet to mounting plate.
Magnet (Rear View)
Mounting
Plate
Apply to frame
49-118
www.radioshack.com
What’s Included
Alarm Magnet Key (2) Adhesive Strip (3) Screw (4) Anchor (4) Drilling Template User’s Guide Actual product may vary from the images
found in this document.
Battery Notes:
Dispose of old batteries promptly and properly. Do not burn or bury them.
Use only fresh batteries of the required size and recommended type.
Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
If you do not plan to use the alarm for a month or more, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.
Installing Batteries
1. Remove the screw on the bottom of your alarm and lift the battery compartment cover.
2. Insert two AAA batteries (not supplied), as indicated by the polarity symbols (+ and -) marked inside.
3. Replace the cover.
4. Replace the batteries if the alarm sound weakens or the LED flashes red. If the alarm does not work after you replace the batteries, remove and reinstall them.
5
/16 “ max
©2007. RadioShack Corporation. All rights reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
09A07
49-118
Printed in China
Loading...