Radio Shack 43-3541, 43-3542, 43-3543, 43-3533, 43-3534 User Manual

0 (0)
Radio Shack 43-3541, 43-3542, 43-3543, 43-3533, 43-3534 User Manual

;22/*\"%QTFNGUU"6GNGRJQPG

YKVJ"*GCFUGV",CEM

43-3533/3534/3541/3542/3543

10-Number Memory Dialing — lets you store up to 10 numbers (1 one-touch and 9 speed-dial) in memory for easy dialing.

20 Channels — you can automatically select a clear channel when you make or answer a call, or you can manually change channels.

Ample Talk and Standby Time — the supplied battery (when fully charged) provides about 7 hours of talk time or 14 days of standby time.

Page — lets you send a paging signal from the base to the handset to page someone or locate the handset.

Quick Talk— lets you set the phone to answer a call by simply lifting the handset from the base.

#"+/2146#06"#

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

— Warning # — Important . — Caution

° — Hint ± — Note

OWNER’S MANUAL

Please read before using this equipment.

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. ENERGYSTAR and the ENERGYSTAR certification mark are registered US marks.

Instructions Safety Important

WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture.

 

..CAUTION..

 

!

RISK OF ELECTRIC SHOCK

 

DO NOT OPEN

 

 

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

The lightning symbol is intended to alert you to the presence of uninsulated dangerous voltage within this product’s enclosure that might be of sufficient magnitude to constitute a risk of electric shock. Do not open the product’s case.

The exclamation symbol is intended to inform you that important operating and maintenance instructions are

!included in the literature accompanying this product.

As an ENERGYSTAR Partner, RadioShack Corporation has determined that this product meets the ENERGYSTAR guidelines for energy efficiency.

+/2146#06"5#('6;" +05647%6+105

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Never install telephone wiring during a lightning storm.

4.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

5.Never touch uninstalled telephone wires or terminals unless the telephone line has been disconnected at the network interface.

6.Use caution when installing or modifying telephone lines.

7.Do not fix the AC power supply cord to building surfaces with metal fittings (if the product has an AC power cord).

8.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

9.Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

10.Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.

11.Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided.

12.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your local power company.

13.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be stepped on.

14.Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

2

15.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

16.To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified service technician when service or repair work is required. Opening or removing covers may expose you to dangerous voltage or other risks. Incorrect reassembly can cause electric shock when the product is subsequently used.

17.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

When the power cord plug is damaged or frayed.

If liquid has been spilled, into the product.

If the product has been exposed to rain or water.

If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.

If the product has been dropped or the cabinet has been damaged.

If the product exhibits a distinct change in performance.

18.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

19.Do not use the telephone to report a gas leak in the vicinity of the leak.

$#66'4;"5#('6;"+05647%6+105".

1.Use only the appropriate type and size battery pack specified in the instruction manual provided for this product.

2.Do not dispose of the battery pack in a fire. The cell may explode. Check with local codes for possible special disposal instructions.

3.Do not open or mutilate the battery pack. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

%106'065

Important Safety Instructions .....

2

Introduction ................................

4

Installation ..................................

4

Connecting and Charging the

 

Battery Pack ............................

5

Setting the Ringer Tone ..........

6

Setting the Dialing Mode .........

6

Operation ...................................

7

Making and Receiving Calls ....

7

Selecting the Channel .............

7

Adjusting the Handset’s

 

Volume ....................................

7

Using Redial ............................

7

Using Flash .............................

7

Using Tone Services on a Pulse

Line .........................................

8

Paging .....................................

8

Using a Headset .....................

8

Memory Dialing .......................

8

Troubleshooting .......................

10

Care ..........................................

11

Service and Repair ....................

11

Important Information ................

11

FCC Statement .........................

11

Lightning ...............................

12

."%#76+10".

To reduce the risk of fire or injury, read and follow these instructions.

Important Safety Instructions

3

Introduction

#"+/2146#06"#

Cordless phones such as this one require AC power to operate. When the power is off, you cannot make or receive calls using your phone. To be safe, you should also have a phone that does not need AC power to operate (not a cordless phone), so you can still make and receive calls if there is an AC power failure.

When AC power is lost, the phone loses the security access-protection code connection between the base and the handset. When power is restored, put the handset on the base briefly to restore this connection so you can use the handset.

Your phone operates on standard radio frequencies as allocated by the FCC. It is possible for other radio units operating nearby on similar frequencies to unintentionally intercept your conversation or cause interference. This possible lack of privacy can occur with any cordless phone.

."%#76+10".

You must use a Class 2

!power source that supplies 9V DC and

delivers at least 210 mA. Its center tip must be set to positive and its plug must fit the phone's DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.

• Always connect the AC adapter to the phone before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the phone.

4.Exercise care in handling the battery pack in order not to short it with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

5.Charge the battery pack provided or identified for use with this product only in accordance with the instructions and limitations specified in the instruction manual provided for this product.

6.Observe proper polarity orientation between the battery pack and battery charger.

5#8'"6*'5'"+05647%6+105

+0641&7%6+10

Thank you for purchasing the RadioShack 900 MHz Cordless Telephone. Your phone uses the 900 MHz band for less interference, clearer sound, and greater range than 46/49 MHz cordless telephones. Its headset jack means you can connect an optional headset for hands-free convenience. #

+056#..#6+10

You can place the phone on a desk or table, or mount it on a standard wall plate or directly on a wall. Select a location that is:

near an accessible AC outlet

near a telephone line jack

out of the way of normal activities

away from electrical machinery, electrical appliances, metal walls or filing cabinets, wireless intercoms, alarms, and room monitors

away from other cordless phones

The base’s location affects the handset’s range. If you have a choice of several locations, try each to see which provides the best performance..

Your telephone connects directly to a modular telephone line jack. If your telephone wiring does not have a modular jack, you can update the wiring yourself using jacks and adapters (available at your local RadioShack store or online at RadioShack.com), or have the telephone company update the wiring for you. You must use compatible modular jacks that are compliant with Part 68 of FCC Rules. The USOC number of the jack to be installed is RJ11C (or RJ11W for a wall plate jack).

4

Loading...
+ 8 hidden pages