ADDENDUM
Wireless lapel microphone system
32-1257
Warning: Modifying, tampering with, or adjusting this
unit, or replacing any transmitter component (crystal,
semiconductor, etc.) may result in a violation of the
FCC rules.
FCC NOTICE
This wireless microphone system complies with Part
90 of the FCC Rules. There are three frequencies
available for the system. You must obtain a license for
each frequency you plan to use before operating your
system. One license can include both frequencies.
Visit http://wireless.fcc.gov/uls/, or call your local FCC
office to apply for your license. Your ability to obtain a
license will depend on how you plan to use the system.
For RF exposure
“IMPORTANT NOTE: To comply with the FCC RF exposure
compliance requirements, no change to the antenna or
the device is permitted. Any change to the antenna or the
device could result in the system exceeding the RF
exposure requirements.”
For devices less than 200mW ERP
SAFETY INFORMATION
Your wireless microphone contains a low power
transmitter. When the EUT is powered on, it sends out
radio frequency (RF) signals. In August 1996, the Federal
Communications Commissions (FCC) adopted RF
exposure guidelines with safety levels for wireless devices.
IMPORTANT
To maintain compliance with the FCC’s RF exposure
guidelines, hold the transmitter and antenna at least
1 inch (2.5 centimetres) from your face and speak in a
normal voice, with the antenna pointed up and away from
the face. Ensure that the antenna is at least
1 inch (2.5 centimetres) from your body when you are
using your wireless microphone.
Use only the supplied antenna. Unauthorized antennas,
modifications, or attachments could damage the transmitter
and may violate FCC regulations.
AE0019AAA1
Printed in China
Loading...