Radio Shack 15-124 User Manual

15-124
what’s included
specications
rf emissions information
limited 90-day warranty
using your receiver
2.4 GHz Digital Audio Receiver
Thank you for purchasing your 2.4 GHz Digital Audio Receiver from RadioShack. This add-on receiver is designed for use with your 2.4 GHz USB Connection Digital Audio Link.
Power indicator
Lights when your transmitter (not supplied) and receiver link.
Receiver
AC Adapter
3.5mm Stereo Y-Type Patch Cable
Your receiver works with the transmitter of your
2.4 GHz USB Connection Digital Audio Link. Refer to the user’s guide of your 2.4 GHz USB Connection Digital Audio Link before using your receiver.
Connect the 3.5mm stereo Y-type cable or 3.5mm stereo audio cable, then connect the other end to your stereo’s audio input jacks.
To avoid injury, do not connect the provided
Notes
power adapter to a ceiling outlet.
Use only an adapter that supplies 9V DC and delivers at least 200mA. Its center tip must be set to positive.
• Unplug the AC adapter from the AC outlet before unplugging from the receiver.
• For better performance and greater reception range, keep the receiver and transmitter away from wireless LAN access points, microwave ovens, and wireless networks or phones that run on 2.4 GHz frequency.
Connect the 9V AC adapter, then plug the other end into a standard AC outlet.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult your local RadioShack store or an experienced radio/TV technician for help. If you cannot eliminate the interference, the FCC requires that you stop using your
receiver. Changes or modications not expressly approved
by RadioShack may cause interference and void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Product
Model 15-124
Responsible
Party
2.4 GHz
Digital Audio Receiver
RadioShack 300 RadioShack Circle Fort Worth,TX 76102
3.5mm Stereo Audio Cable
User’s Guide
Please read this user’s guide before
installing, setting up, and using your new receiver.
www.radioshack.com
©2007. RadioShack Corporation. All rights reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
Printed in China
15-124
02A07
Frequency Range ...................................................2.4 ~ 2.4835 GHz
Channel Frequency ..................................... 2410, 2419 ~ 2473 MHz
Channel Spacing ...................................................................... 9 MHz
Frequency Stability ............................................................... ±1 MHz
Transmission Range ........................45 ft (15 m, in the home) (Max.)
....................................................
Operating Temperature ........................... 32°F to 104°F (0°C to 40°C)
Power Supply ...................................... 120VAC/60Hz, 9V DC/200mA
Response ................................................................ 20 ~ 20kHz±3dB
S/N Ratio ...........................................................................40dB (Min.)
Sensitivity ................................................................. −85 dBm (Min.)
Output Impedance ........................................... >10K Ohm (3.5 mm)
Output Level ...................................................................2 Vms±10%
Dimensions (H x W x D) .......................................3.4 x 3.4 x 1.3 Inch
...............................................................................
Weight ............................................................................2.29 oz (65 g)
Specications are subject to change and improvement without
notice. Actual product may vary from the images found in this
document.
100 ft (30.5 m, line of sight) (Max.)
(86 x 86 x 32 mm)
Phone 817-415-3200
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. For complete warranty details and exclusions, check with your local RadioShack store.
RadioShack Customer Relations 300 RadioShack Circle, Fort Worth, TX 76102 04/04
Loading...