Radio Shack 15-1186 User Manual
g
g
g
g
/
t
15-118 6.fm Page 1 Thursday, Ju ly 15, 1999 1:4 7 PM
Cat. No. 15-1186
To mount the
1. If there is no wall box, cut a 1
2. Across the top of the hole, position a flat bracket
TV FM Flush Mount Wall Plate
wall at the desired location.
piece a
ainst the i nner wall sur face and a n angled
bracket piece a
recessed part inside the hole).
ainst the outer wall surface (with the
3
:
/4 ¥ 4 inch hole in the
(L) illus of hole on wall w
dimension lines
(R) illus of wall cross-sec
w/brackets and screws;
size to fit text margins
3. Thread two o f the supplied lon
two outer holes on the bracket pieces.
4. Repeat Steps 2 and 3 a cros s th e botto m of the hol e
so the center hole in the bottom bracket is 3
inches below the center ho le in the top bracket (to
match the distance between the moun tin
the wall plate).
Custom Manufactured in Taiwan for RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
bolts through the
holes on
1
/
4
g
g
(
)
g
w
15-118 6.fm Page 2 Thursday, Ju ly 15, 1999 1:4 7 PM
illus of hole on wall
brackets in place
size to fit text
margins
5. Use a Phillips screwdr iver to loosen the two screws
on the back of the wall plate. Connec t the antenna
cable/wires from inside the wall to the rear conne ctors on the plate, then reti
Warning:
cables/wires do not touch each other.
6. Use the two supplied short screws to secure the
plate to the center holes of the brackets.
7. Use a flat-bladed screwdrive r to loosen the screws
at the back of the supplied three-pron
Connect the 300-ohm ante nna wire from the audio
and video outputs of the TV
channels of the FM radio
the screws.
8. Insert the plu
12A98 Printed in Taiwan
Be sure the exposed portions of the
into the wall plate’s jack.
hten the screws.
cable plug.
or the left and right
to the plug, then retighten
Loading...