Service Manual
SC 4040 Slider
SC 4040 Slider
Click the Procedure to View
Operation and Maintenance Procedure 2
Door Is Not Closing 3
Door Adjustment 4
Slide Rail Replacement 4
Door Guide Replacement 4
Cable / Weight Removal 5
Cable / Weight Replacement 5
Magnet Adjustment 6
Magnet Replacement 6
Parts and Descriptions 7-8
Warranty Service Policy 9
Quikserv Corp.© quikserv.com • 1-800-388-8307 • Fax (713) 849-5708
1
Service Manual
SC 4040 Slider
SC 4040 Model
Operation and Maintenance Procedures
Pre-Operation Procedures:
• Unlock all locking mechanisms and ensure
that the door is free of obstructions.
General Cleaning Guidelines:
• All weather-stripping should be checked and
cleaned weekly.
• All glass, aluminum framing, and stainless
steel should be kept clean at all times. All
cleaning uids and applicators should be
non-abrasive.
• Bottom bases should always be kept clean
and clear of objects obstructing normal
operation (i.e. - dirt, grease, paper, etc.).
General Maintenance:
• Slide rail should be kept clean of all dirt and
debris.
• Rails should be oiled with lightweight oil
every 6 months.
• Hook lock & thumb turn should be cleaned of
all dirt and debris every 6 months.
To gain access to the internal components for each window the access panel
must be removed from the exterior of the
window - see arrows below.
Access Panel Removal:
To gain access to the slide rail system, the
access cover panel must rst be removed. The
cover panel is located at the top of the header
on the operator’s side of the window.
Remove the screws protruding from the cover
panel. - See arrow below.
Please refer to the Trouble Shooting Section
in this manual for additional information on the
window adjustments or service procedures.
Contact us at (800) 388-8307 for assistance or
for information on the nearest service center in
your area.
Quikserv Corp.© quikserv.com • 1-800-388-8307 • Fax (713) 849-5708
2
Trouble Probable Cause Probable Solution
1. Door dragging Adjust door
2. Unit installed out of square Contact construction company
3. Door obstructed Remove obstruction
4. Defective slide rail Replace or oil slide rail
5. Door guide worn or bent See door guide replacement
6. Defective cable assembly See cable diagram
7. Weight stuck
8. Magnet in hold-open position
Place magnet cap on magnet
and make adjustments
Door is Not
Closing
K
H
ACCESS COVER PLATE
FOR DOOR WEIGHT
DOOR WEIGHT
CABLE
CABLE
K
M
J
D
B
A
O
CENTER JAMB
S/S BASE
SIDE JAMB
HEADER
DOOR
DOOR
CABLE ROLLER ASSEMBLY
SIDE VIEW
DOOR CABLE BRACKET
SIDE JAMB
ACCESS COVER PANEL
F
Service Manual
SC 4040 Slider
Trouble Shooting Procedures
Quikserv Corp.© quikserv.com • 1-800-388-8307 • Fax (713) 849-5708
3
Loading...