Quantum UC1000, UC4000 Installation Manual
Quantum UC1000
Premium Quality
Drinking Water System
Installation Guide
UC1000 / 4000
UC1000 Installation Guide
www.danamark.com
DANAMARK WATERCARE
90 Walker Drive, Brampton, ON L6T 4H6 | 1 888 DANAMARK | T 905 792 2353 | F 905 792 2986
Item
Part Number
Description
Qty
A
Q1000
Quantum 1000 Filter Cartridge
1
B
QH3
Quantum Head
1
C*
3046-44
Mounting Bracket
1
D*
3081-31
Restrictor Fitting (Outlet)
1
E*
PI011223S
Male Connector (Inlet)
1
F
CI3208U7S
Faucet Connector
1
G
FCTT8-520
Teflon Tape
1
H
PPASV121208W
Angle Stop Adaptor
1
I
MS1034
SS Mounting Screws (Phillips)
2
J
TBL14
¼” Blue Waterline
10’
K
9970-56
Designer Series Chrome Faucet
1
*Installed on (B) Quantum Head
Item
Description
Qty
K1
Brass Escutcheon (with O-Ring)
1
K2
Black Locating Washing
1
K3
Lock Washer
1
K4
Nut
1
K5**
Compression Nut
1
K6**
Tube Support/Insert
1
K7**
Delrin Sleeve
1
**Used in place of (F) CI3208U7S for compression fitting installations
A
B
C
E D
K
F
H
G
I
J
(K1) Brass Escutcheon &
Rubber O-Ring
Countertop
(K3) Lock Washer
(K4) Nut
(F) Faucet Connector
(K2) Black locating washer
Use tapered side down for ½” hole
Contents
Contents of Designer Series Chrome Faucet
(Part # 9970-56)
Thank you for purchasing a Danamark Quantum Under Counter
Drinking Water System. Rest assured that you have purchased the very
finest in point-of-use water purification. Should you have any questions
or concerns, please call us at:
1-888-DANAMARK (1-888-326-2627)
Preparation For Installation: *Important: Use only on cold water supply*
1. Shut off cold water supply to sink.
2. Relieve line pressure by opening the cold water tap for a few seconds until water stops; then close the tap.
3. Select a suitable location to mount (B) Quantum Head and (A) Cartridge, leaving approximately 2” of space
below cartridge for ease of future cartridge changes.
4. Select a suitable location to mount (K) Chrome Faucet, minimum of 1” from edge of the sink.
Tools Required:
- Phillips screwdriver
- ½” Drill bit and drill
- Adjustable wrench
Installation of Faucet:
1. When drilling the countertop; place the (K1) Escutcheon plate,
with dome face up, 1/8” from the back of the countertop and a
minimum of 1” from the edge of the sink. Use as a template to
drill a ½” hole.
2. Assemble faucet as shown on diagram to the right.
3. Wrap threaded faucet stem with the provided (G) Teflon tape.
4. Tighten (F) Faucet Connector to the threaded faucet stem.
Loading...