Pyramid Car Audio TLM606NC User Manual
INSTALLATION
SPECIFICATION
NORMAL
EQ Center Frequencies...............................................................10 BAND.
Equalization Range.......................................................................+/- 10dB
INSTRUCTION MANUAL
Frequency Response @ 3dB Down..........................................20Hz - 20KHz
Channel Separation...........................................................................45dB
T.H.D. @ Reference Output.................................................................0.5%
10% T.H.D. Output Power.............................................6X4CH./16X2CH.W
MAX. Output Power.....................................................2X100/4X50 Watts
Power Requirements : 11-16V DC negative ground, 5 Amp, Maxiam.
Accessories included : Mounting brackets for optional under-dash, mounting
trimplate.
Dimensions [W X H X D] : 153 X 27 X 121mm.
Due to out continuing efforts towards product improvement, the above
specifications are subject to change without notice.
200 WATTS OUTPUT
BEFORE INSTALLATION /OPERATION
READ THIS MANUAL COMPLETELY
MODEL: 901GC
This model is intended for those who value the acoustic benefits of a
multi - band Graphic Equalizer but who also desire higher audio power level
capabilities than can be obtained in an in-dash unit. Being a passive Equalizer, it
contain power amplifiers to drive speakers directly, Also provides one stereo
signal line output and 1 pair sub-woofer output can be connected to remote highpower amplifiers. The ten center-frequencies are connected in the critical
50Hz to 12Hz region where compensation is most needed.
LOCATION AND FUNCTION OF CONTROL
1. FADER KNOB
Allow front to rear balancing in four speaker systems for best directional
imaging.
2. EQ KNOBS
Each slide controls the amount of boost or cut in one small part of the total
audio frequency range. With all slides in the center position, the overall
frequency response is flat. By moving any slide up or down. The output
within the band is increased or decreased by up to 12db.
3. LED INDICATOR
WIRING CONNECTION
CAR RADIO
SPEAKER OUTPUT
L +
L R +
R -
GREY
GREEN
GREY/WHITE
L R
GREEN/WHITE
2 SPEAKER SYSTEM
PRECAUTIONS
1. Most speaker systems require rather heavy boost at the lowest
frequencies due to the large amount of air that must be moved. Speaker
woofer cones responder between 45-60Hz where output is higher so do
not boost much at 60Hz. Use heavy boost at 100Hz, less boost at
400Hz.
2. Due to sound-wave reflections between the front and rear windshields of
a typical vehicle, there may be heavy loss between 700Hz to 1.3KHz so
moderate boost here is very effective and will create more presence for
vocalists.
3. The mid-range from 3 to 6KHz should not require much change from
flat [center] most speakers work well here. Adjust per your taste.
BROWN
BLUE
BROWN/WHITE
BLUE/WHITE
L+IN YELLOW
L-IN YELLOW/WHITE
R+IN PURPLE
R-IN PURPLE/WHITE
7A FUSE
B+
RED
BLACK
B -
F. L
R. L
GREY
GREY/WHITE
GREEN
GREEN/WHITE
4 SPEAKER SYSTEM
BROWN
BROWN/WHITE
BLUE
BLUE/WHITE
F. R
R. R
4. POWER BUTTON
Press it to turn on or off the unit.
4. Due to limitations in human hearings. Sound above 8KHz is not heard
very well. Moderate boost at 1KHz adds a crisp character when
percussion instruments are present.
Loading...