Puretec UFC User Manual

Download

Page 1

UFC Series User Guide

High pressure Filter Housing

For correct operation & installation it is essential to observe these instructions.

FEB2017

Page 2

Puretec Customer Service

Thank you for purchasing a Puretec Drinking Water Appliance. Your system is a proven performer manufactured from only quality materials and components. It will give years of reliability and trouble free operation if maintained properly.

This user guide is designed for Puretec Drinking Water Appliance. Be careful to ensure the information and illustration is applicable to your particular unit.

Caution: Do not use with water that is microbiologically unsafe or without adequate

disinfection before or aer the system.

Flush system for 5 minutes or more, aer any period of non-use, more than 2 weeks.

Note: For point of entry installations an approved dual check backow prevention device must be installed. Where maximum line pressure exceeds 690 kPa, a pressure limiting valve must be installed.

AUSTRALIA

Customer Service: 1300 140 140 Email: sales@puretec.com.au Web: www.puretec.com.au

NEW ZEALAND

Customer Service: 0800 130 140 Email: sales@puretec.co.nz Web: www.puretec.co.nz

Customer Support Established Manufacturer On the road support

Page 3

UFC Series User Guide

What's Inside

Puretec Customer Service .............................................................................................................................. 2

Installation Record .............................................................................................................................................. 4

Before Installation ................................................................................................................................................ 4

Specications .......................................................................................................................................................... 5

Installation Procedure ........................................................................................................................................ 6

Filter Maintenance ............................................................................................................................................... 7

Warranty .................................................................................................................................................................... 9

Page 4

Introduction

This product is a high pressure lter and can lter tap water, ground water, cooling water, RO extraction and trade waste water by bag ltration or an RO reverse strain core.

The lter is made of from stainless steel and is welded to ensure maximum strength. The housing cap can be completely removed from the housing making lter change easy.

The lter is tted with an adapter to suit multiple types of cartridge styles. A xed lip on the inside of the lter is used for securing a bag lter and a bag lter basket protects

the bag from damage

Page 5

UFC Series User Guide

PRODUCT INFORMATION

Model Number

Serial / Batch Number

Purchased from:

Date of Installation

Installer / Plumber Details

Installation Record

For future reference, ll in the following data

Before Installation

Read the instructions, check that there is no damage to the unit and check if there is adequate space to mount the components. This product is a pressure vessel and

adjustment to the unit should be done by a qualied professional such as a boilermaker.

Note: Not all ttings are supplied with the unit. Isolation valves are not supplied.

Check the mains water pressure is between 172 - 690kPa

NOTE: This product must be tted to MAINS WATER ONLY

Page 6

Specications

Specications

Operating pressure min/max (water) 0 - 690 kPa

Operating temperature min/max 4 - 99°C

Inlet/outlet connection 50mm Flange

Page 7

UFC Series User Guide

Specications

Page 8

Installation

This lter housing must be installed on solid level ground. Vibration mounts can be used

to reduce the risk of tank rupture if the unit is being mounted near heavy machinery.

A pressure relief valve should be installed before the inlet to protect the system from pressure surges.

The use of union ttings before and aer the unit is advised to allow for unit removal

during servicing.

All attached pipe work should be independently supported and should not induce any

load on the lter housing.

INSTALLING THE UNIT

1. Connect the water inlet pipe work to the inlet ange.

2. Connect the water outlet ange to the outlet pipe work.

3. Install the drain valve in the drain port on the underside of the unit.

4. Install the pressure gauge and vent valve to the vent port on the cap of the unit.

5. Undo the clamp and remove clamp.

6. Remove the lter housing lid.

7. Undo the nut on the cartridge adaptor and remove the adaptor from the lter housing.

8. Remove the top plate from the adaptor.

9. Insert the adaptor into the centre of the cartridge and reattach the top plate of the adapter.

10. Make sure the adapter components are all aligned withing the centre of the lter

cartridge.

11. Fasten the nut until rm and install the lter cartridge into the housing.

12. Check the O-ring is in the grove on the lip of the lter housing.

13. Place the housing lid in place and install the clamp.

14. Tighten the clamp screw tightly.

15. Close the drain port

16. Open the vent valve.

17. Open the water ow

18. Close the vent valve when water ows from the vent.

19. Check the unit pressure to ensure there are no leaks.

Page 9

UFC Series User Guide

Maintenance

SYSTEM MAINTENANCE

Before performing any maintenance please close the inlet valve and release pressure via the drain port.

MAINTENANCE CYCLE

Filter housing Keep the lter housing clear of debris and

sharp objects or unnecessary items.

Everyday

Pressure gauge Check that the pressure is within the correct

specications

Everyday

Water outlet Check for leaks Everyday

Water inlet Check for leaks Everyday

Tank body Make sure there are no cracks or stress

marks on the housing or any welds

Monthly

Support frame Make sure there are no cracks or stress

marks on the support frame or any welds

Monthly

Housing lid Check for leaks and ensure O-ring is

lubricated. Replace O-ring if perished.

Monthly

Filter bag Replace with new lter bag Monthly

If any damage, stress or cracks are fount in either the housing, frame or any welds, please do not use the unit and contact Puretec immediately.

Page 10

Dierential pressure

It is important to regularly check the pressure dierential across the unit during operation. Operating above the recommended pressure will aect the ow rate and reduce the eciency. When the dierential pressure exceeds 1.10kg/cm2 it is time to replace the bag lter. (See pg.6)

If the pressure dierential drops suddenly, cease operation and isolate the unit, purge

the water from the unit and check the unit thoroughly for stress or fractures. Sudden

pressure uctuations can cause seal failure and/or lter rupture.

A lack of dierential pressure indicates that no ltration is taking place. When ltration

is taking place the inlet pressure should be slightly higher than the outlet pressure.

Dierential pressure will gradually increase as the lters start to retain more debris. If a lack of dierential pressure is detected, stop the system and check for seal leaks or

housing ruptures.

Operation

Page 11

UFC Series User Guide

WARRANTY

Any claim under this warranty must be made within 1 year of the date of purchase of the product. This product is warranted to be free of defect of material and workmanship for 1 year from date of purchase. To make a claim under the warranty, take the product and proof of purchase to place where you purchased the product, and they will lodge a Warranty Request with Puretec.

Puretec will pay your reasonable, direct expenses of claiming under this warranty. You may submit details and proof of your expense claim to place of purchase for consideration.

The warranty only applies if the product was used and/or installed in accordance with the user guide and/or installation instructions. This warranty is given in lieu of all other express or implied warranties and manufacturer shall in no circumstance be held liable for damages consequential or otherwise or delays caused or faulty manufacturing except as excluded by law.

Applicable to all above, is that the Warranties need to be approved by Puretec to ensure product was not incorrectly used, installed or claimed. False and incorrect claims will be pursued at Puretec’s discretion, including chargeable inspection and labour costs incurred.

WARRANTY / AUSTRALIA

This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 14-16 Bailey Street, St Marys SA 5064, telephone no. 1300 140 140 and email at sales@puretec.com.au.

This warranty is provided in addition to other rights and remedies you have under law: Our goods come with guarantees which cannot be excluded under the Australian Consumer Law. You are entitled to replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

WARRANTY / NEW ZEALAND

This warranty is given by Puretec Ltd, Reg. No 4464398, 47 Allwill Drive, Cambridge NZ

3493, telephone no. 0800 130 140 and email at sales@puretec.co.nz.

This warranty is provided in addition to other rights and remedies you have under law: Our goods come with guarantees which cannot be excluded under the Consumer Guarantees Act. You are entitled to replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Warranty

Page 12

Puretec water care products are designed, manufactured and supported by Puretec Ltd the name you can trust for viable and proven water

solutions. The complete range of Puretec products are developed, rened, made to meet and exceed stringent specications for the worldwide

market. All pictures and information are supplied as a guide only. *Fittings not Included. ^3 Year Platinum Protection applies to Puretec Systems

when used in conjunction with a Puretec lter cartridge. Warranty excludes cartridges.

Important Note: Sales of products are subject to our Terms and Conditions which are available upon request. All specications, information and photos are a guide only and are subject to change without notice. Please ring to conrm details. Warning: For correct operation of this appliance it

is essential to observe manufacturer’s instructions. Caution: Do not use with microbiologically unsafe water or water of unknown quality without

adequate disinfection before or aer the system. Under normal circumstances a pressure limiting valve is not required. However, if incoming water pressure exceeds 875 kPa, a pressure limiting valve must be tted prior to inlet. Copyright © Puretec Ltd 2016

Puretec UFC User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual