SPECIAL HYPERLITE™ POCKET NOTICE
Precision Shooting Equipment, Inc. 2/10/06
The new HyperliteTM Pocket System is unlike that on any other
bow. Some special considerations must be followed so that the
system continues to function properly.
• IMPORTANT: Do not adjust the pocket alignment
set screws. If your bow is equipped with this feature,
there is one setscrew used to locate the horizontal
position of each pocket (Figure 1). They are factory set
to the proper depth and secured in place with Loctite
Threadlocker. Any changes from the factory position
may create noise and/or damage the bow.
• IMPORTANT: Do not “bottom” the limbs against
the riser on a bow equipped with the Hyperlite
Pocket System! Traditional limb pockets use a
“bottomed” position to determine peak weight. This
position is where the limb, pocket and riser contact one
another simultaneously. Due to the compact design of
the Hyperlite
position does not exist. The “bottomed” position for
Hyperlite
TM
Pocket System, the “bottomed” limb
TM
pockets is where the bottom surface of the
limb is approximately .20” (3/16” or 5 mm) away from the
riser (Figure 2). The limb bolt may be adjusted to slightly
increase the draw weight, but the gap between the limb
and riser must never be less than .15
” (4 mm). Always
loosen the limb bolt set screws when adjusting limb
bolts. Retighten after adjustments are made.
• IMPORTANT: Loosen the barrel location set screw
before making weight or tiller adjustments to a bow
equipped with the HyperliteTM Pocket System! Some
bows equipped with the Hyperlite
TM
Pocket System use
a barrel-locating setscrew (Figure 3). This setscrew has
a conical point that engages a groove in the limb bolt
barrel (Figure 4). Before the bow is placed in a bow
press for service or bow weight adjustments are made,
loosen these screws up to 1/2 turn from the locked
position so that the barrel is free to swivel but the point of
the set screw remains in the groove. Re-tighten these
setscrews before shooting the bow.
TM
®
Pocket Alignment
Setscrew.
DO NOT ADJUST!
Figure 1
Limb Bolt
Setscrew
Figure 2
Barrel Location
Setscrew
Figure 4
Limb Bolt Set Screw
Limb Bolt Barrel
Groove
Figure 3
Loading...