PSE Archery Crossbow User Manual
Crossbow
Owner’s Guide
Read these instructions carefully before
operating your PSE crossbow.
Distributed by:
®
® ®
CROSSBOW OWNER’S GUIDE CROSSBOW OWNER’S GUIDE
Thank you for purchasing your new crossbow! With proper
use and care your crossbow will provide years of enjoyment.
Keep this manual with your crossbow for reference.
Limited Lifetime Warranty
PSE warranties every compound crossbow to be free of
defects in material and workmanship for the period as
dened below.
1) PSE crossbow stocks, metal prods and cams, if
defective, will be replaced at no charge for the
lifetime of the product.
2) Limbs, if defective, will be replaced at no charge for
the rst year, and at 50% of the replacement cost
thereafter.
3) Evidence of mishandling, abuse or modication of the
product or use of non-PSE replacement parts voids the
warranty.
4) Cables, strings and vibration dampers are wearable
items and are not covered by this warranty.
All warranty work will be performed by PSE or your local
PSE Crossbow dealer.
PSE makes no other warranty claims whether expressed or
implied. This warranty applies to the original owner only, and
does not cover cables or strings.
Safety
1) ALWAYS treat your crossbow as you would any weapon
or rearm. It is a powerful weapon that can be deadly if
mishandled.
2) ALWAYS keep your crossbow pointed in a safe direction.
Never point your crossbow at anything you don’t intend to
shoot.
3) NEVER enter a vehicle with a loaded crossbow. Always
uncock and properly stow your crossbow for transporting.
4) ALWAYS check your crossbow to make sure that it is in
proper mechanical order. Check for damaged, worn, loose
or missing parts.
5) NEVER dry re your crossbow. Firing the crossbow without
an arrow will cause damage not only to the crossbow but
possible bodily injury to you and anyone in the area. It also
voids the warranty.
6) DO NOT make changes or alterations to any parts of this
crossbow as it may cause an unsafe condition and will void
the warranty.
7) NEVER release the safety on your crossbow until you are
ready to shoot and are sure of your target.
8) NEVER shoot any arrow or other projectile from your
crossbow that has not been recommended by PSE. Use
only arrows of the proper size, weight and length.
9) ALWAYS keep your ngers and thumb out of the path of the
string and cables while shooting your crossbow. Failure to
do so will cause injury.
WARNING:
Use extreme caution while operating this weapon. Never
walk, run, crawl, ride a horse, ATV, or motorcycle or travel
in a vehicle with a loaded or cocked crossbow. Accidental
discharge could prove harmful or fatal.
2 3
® ®
CROSSBOW OWNER’S GUIDE CROSSBOW OWNER’S GUIDE
Compound Crossbow Assembly
Before shooting your crossbow, some basic assembly is required.
Mount prod to stock assembly. Clip the cable slide (A)
on top of the cables with one cable in each slot.(Fig.1)
Place slide in the center of the prod.(B) Slide cables and
slide into cable slot of stock assembly with the string riding
on top of the rail. Insert the prod into stock assembly (D) as
shown in (Fig. 2) and secure with the prod attachment screw
(E) (Fig. 3), Tighten screw with the Allen key provided (F).
Place the stirup (C) into the front mounting holes of the prod
assembly (Fig. 4) and tighten the set screws (G)
Fig. 1
B
Prod
Fig. 2
G
C
Stirrup
(set screws pre-installed in prod)
Set Screws
Fig. 3
D
Fore-end
Stock assembly
F
E
A
Fig. 4
Prod Assembly Mounting Bolt
Left) for Reaper and Copperhead
Right) for Foxre and Crossre
Right) for synthetic cable system
Cable Slides
Left) for steel cable system
4 5
Loading...