Proteus EEC-7000 Owner's Manual

Owner's manual

OMETER MAGNETIC
PROGRAMMABLE
ELLIPTICAL

ERG

EEC-7000

- 1 -

EEC-7000 ERGOMETER MAGNETIC
PROGRAMMABLE ELLIPTICAL ASSEMBLY INSTRUCTION

STEP 1.

a. FIT FOOT CAPS ( 23 ) TO END OF THE

REAR STABILIZER AND CAPS ( 21 ) TO END
OF THE FRONT STABILIZER.

( PLEASE REFER TO FIG. A )

b. THE CAPS ( 21 ) SHOULD BE TIGHTENED

WITH FOOT ADJUST BASE ( 22 ).

( PLEASE REFER TO FIG. B )

STEP 2.

a. CONNECT EXTENSION CABLE WIRE ( 08 )

AND LOWER CABLE WIRE ( 09 ).

b. FIT HANDLEBAR POST ( 02 ) TO THE MAIN

FRAME ( 01 ) BY USING M8 CARRIAGE
BOLTS ( 33 ), M8 SMALL WASHERS ( 44 ),
M8 NYLON NUTS ( 46 ) AND M8 HALF
MOON CAPS ( 47 ).

( PLEASE REFER TO FIG. C )

- 2 -

STEP 4.

a. FIT HANDRAIL TO CONNECTING ARM ( 04 )

WITH BOLT ( 34 ), WASHER ( 42 ) & NUT
( 46 ). BE SURE TO TIGHTEN BOLT
FIRMLY THEN FIT HALF MOON CAPS ( 20 )
ON BOTH ENDS.

b. REPEAT SAME PROCEDURE ON

ASSEMBLING THE CONNECTING ARM ( 04 )
& PEDAL ARM ( 05 ).

c. REPEAT SAME PROCEDURE ON THE

OTHER SIDE.

( PLEASE REFER TO FIG. F )

STEP 3.

a. INSERT AXLE SPACER ( 13 ), WAVE WASHER

( 57 ) PIVOT CAP-A ( 14 ), THEN FIT
HANDRAIL ( 03 ) TO THE AXLE BY USING M8
MIDDLE WASHER ( 43 ) AND M8 BOLT ( 36 ).

( TIGHTEN THE BOLT FIRMLY ).

b. FIT ANOTHER PIVOT CAP-B ( 15 ) IN RIGHT

POSITION WITH SLIGHTPUSH ( NO SCREW ).

( PLEASE REFER TO FIG. D )

c. REPEAT SAME PROCEDURE ON THE OTHER

SIDE HANDRAIL ( 03 ).

( PLEASE REFER TO FIG. E )