
Federal Communications Commission StatementFederal Communications Commission Statement
NOTE
The manufacturer is not responsible for any radio or tv i
unauthorized modifications to this
authority.
NOT
E
This equipment has been tested and found to comply with the limits foraclass
Device, pursuant to part 15 of the FCC Rules. These limits are designed to
reasonable protection against harmful interference inaresidential i This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may c
particular installation. If this equipment does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
1.Reorient or relocate the receiving antenna.
equipment. Such modifications could void the user's
guarantee that interference will
nterference caused by
B digital
provide
nstallation.
ause harmful interference to radio
not occur
anionsiereht,revewoH.snoitacinummoC
2.Increase the separation between the equipment and the receiver.
3.Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4.Consult the dealer or an experienced radio/TV technician for help.
1

Preparation for using your new TV
Learning about your TV
Operate your TV via th e buttons located on the front or side of cabinet or use the remote control. The
termina ls located on back of TV provides all the conn ections from other equipment to TV.
View the front connection panel
Power indicator
Remote receiver
View the back connection panel
INPUT
Menu
Input selection
Volume Up
Volume Down
Channel Up
Channel Down
Power(On/Standby)
ENOHPDAEHOEDIV-S
Power Cord Input
HDMI2 HDMI1
AUDIO L R
TUO
R
Y
P
PB
6
VGA AUDIO IN
SERVICE
L
Y P P L R
R
COMP1
B R
COMP2
VGA
RL
NI
OEDIV
LAIXAOC

Preparation for using your new TV
SelectingalocationfortheTV
1. Place the TV on an open stand in a location where light does not directly hit the screen.
2. Place the TV far enough from the walls to allow proper ventilation. Inadequate ventilation may cause
overheating, which may damage the TV.
Please contact a local dealer for wall mounting.NOTE:
Connection to other devices
The side panel connection
COAXIAL
COAXIAL
VIDEO
LR
IN
Yellow
White
Audio L
Video
S-VIDEO HEADPHONE
Red
Audio R
S-VIDEO
The equipment with AV or S-Video
output function ( such as VCR, DVD,
set-top boxes, etc.).
7

Preparation for using your new TV
The back panel connection
The equipment with HDMI output jack
( such as DVD players, set-top boxes, etc.).
Update jack
OR
Computer
White
Audio L
HDMI2 HDMI1
AUDIO L R
OUT
P
PB
Y
Red
Audio R
SERVICE
L
R
R
COMP1
Green
Y
VGA AUDIO IN
YPPLR
BR
COMP2
OR
Blue
Red
White
Red
B
/
/
R
B
PC
Audio L
PC
VGA
Audio R
AUDIO AMPLIFIER
DVD With Component jacks
8

Preparation for using your new TV
Connecting your TV
Caution: Do not plug in the TV until you have finished connecting all of your equipment.
Connecting to an antenna
Toenjoythetelevisonprogram transmittedbyyourlocalTVstation,youneedanindoororoutdoor
antenna (not supplied). An outdoor antenna is necessary for superior picture quality. If you are a
subscriber of your local cable network net, the outdoor or indoor antenna is not needed. Connect the
equipment as shown below.
Side Panel
S-VIDEO HEADPHONE
3.
LR
VIDEO
COAXIAL
1.
IN
2.
Connecting Cable/ Satellite and A/V Equipment
To enjoy the multimedia features, you can connect your TV to A/V equipment such as VCR, DVD, Digital
Video Recorder (DVR), Cable Set Top box, Satellite receiver, BluRay Camcorder, Audio amplifiers, etc.,
and select signal source using your remote control.
Connect RCA audio cables to “R -AUDIO - L” on the rear of your set and the other ends to corresponding
audio out connectors on the A/V device.
NOTE:
1. Headphones are not included.
2. No sound will be heard from the main unit speakers when a headphone mini-plug is
connected into the headphone jack.
Service jack
Connector for service only (do not connect any equipment here).
Connecting component devices (DVD/DVR)
Connect Component video and audio cables to Component inputs (“PR/CR”, “PB/CB”, “Y”) on the rear of your set
and the other ends to corresponding component video out connectors on the DVR or DVD.
The Y, PB/CB and PR/CR” connectors on your component devices (DVR or DVD) are sometimes labeled Y, B-Y and
R-Y or Y, CB and CR (Colors for inputs and cables must correspond to both devices).
NOTE Some devices such as a DVR or DVD players require ’Component/YPBPR’ signal to be set via output in the
:
devices settings. Please consult your device user manual for instructions
.
9

Unit Dimension(unit: mm) Screw Diameter Screw Length(unit: mm)
216M002x002
Remark: The specification of screw is just used on the back cabinet.
NOTE: Wall mount bracket is not included with TV and mounting of wall mount bracket to wall may
vary depending on brand and size of bracket. Customer should consult bracket mounting
instructions that came with wall mount for specific information on how to mount bracket to wall.
Removing TV Stand
1. Cover the surface of the table with soft cloth to avoid damage to LCD panel.
2. Lay the TV on a plane table which could bear a weight enough.
3. Remove the 4 bolts fixing the stand and remove the stand from TV.
Before reading the installing instruction, please notice:
A. The wall mount is not contained in the accessories sold with television. We only provide the installing
specifications but not the wall mount itself. If you need the mount, please consult with the local dealer
for the assorted fitting parts.
B. We strongly suggest to set the wall mount with equipments of specification we ordered. If not,
inappropriate installing may cause damage to both the device and yourself.
23

24
Inches
1366 768
118W
VideoX1
S VideoX1-
ComponentX 2
HDMIX2
AV Audi o X 1
Component Audio X 2
VGA Audio Input X 1
Audio X 1
Coaxial Audio out x 1
Length 31.5 inches:
Wi dth 9.4 inches:
Height 23.5inches:
30.8 lbs
32LC30S60
, Warranty Reg istra tion card
Headphone audi o out x 1
HDMI mod e
31.5
6W+6W